MUL TECHNOLOGIES MARC 3 Series Promat DX User Guide
- June 9, 2024
- MUL TECHNOLOGIES
Table of Contents
MARC 3 Series Quick Start Guide
MARC 3 Series Promat DX
Verify emergency stop button is not activated (pressed in).
Rotate the button clockwise to reset.
Insert battery by sliding onto rails and pushing until fully seated.
Insert key into battery and turn to “On” position. Press the Power button
above the EZ-Go Navigation panel. LEDs will be yellow whilebooting – wait
approximately 2-3 minutes for unit to complete booting – until “Cart ready” is
heard and LEDs begin pulsing green.
Program your first locations.
Note that you may have a 15-button EZ-Go Navigation Panel (Premium models) or a 6-button EZ-Go Navigation panel (Value models). Instructions use the 6-button, but the programming process is the same for both variations.
Press and hold any un-programmed station button (grey) for 3 seconds until you hear the double-beep sound. Station button will turn green, indicating programming completed.
Manually move the cart to a second location you wish to program. Press and hold any un-programmed station button (grey) for 3 seconds until you hear the double-beep sound.
That’s it! You have programmed MARC and can put him to work. Press the station
button for each programmed key (in our example 1 and 3) and MARC will travel
to the destination programmed for that button.
For more detailed instructions for using MARC 3 Series in Active Map Mode
and Fixed Map Mode, please refer to the User Guide.
Please read the included User’s Guide for important instructions and
intended use information to use your product safely! Use QR code to access in
documentation.
https://www.multechnologies.com/documentation
Revision 210806A
Documents / Resources
| MUL
TECHNOLOGIES MARC 3 Series Promat
DX
[pdf] User Guide
MARC 3 Series Promat DX, MARC 3 Series, Promat DX
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>