HANECO ESD40M-SM Lighting Emergency LED Exit Installation Guide
- June 2, 2024
- HANECO
Table of Contents
HANECO LIGHTING EMERGENCY LED EXIT INSTALLATION GUIDE
ESODO EDGE 40M SURFACE MOUNT
ESD40M-SM Lighting Emergency LED Exit
Thanks for choosing our ESDOSO EDGE 40M Emergency Exit Sign.
We strongly recommend that you read this manual carefully before installation.
WARNING
The luminaire must be installed by a licensed/qualified electrician in
accordance with local wiring and relevant Australian standards.
- Ensure to disconnect mains supply before conducting any installation and maintenance on the luminaire.
- Ensure input voltage conforms to the voltage range of product.
- Ensure all the wiring is correct and secured before connecting mains supply to the luminaire.
- Warranty is void if product is not installed according to the instructions.
Product Specifications
PRODUCT
CODE| MAX POWER CONSUMPTION
( WHEN CHARGING )| IP RATING| INPUT
RATING| OPERATING
TEMPERATURE| ELECTRICAL
CLASSIFICATION| EM
TIME
---|---|---|---|---|---|---
ESD40M-SM| 3.7W| IP20| 220 – 240Va.c.
50/60Hz| 0-40°| Class I| >1.5hr
Product Dimension| ESODO Edge 40M Emergency Exit sign can be wall and
ceiling mounted.
---|---
| 
Installation Instructions
- Switch-off mains power.
- Choose the decal suitable for its application. Reference “Replacing the decal” section for instructions.
- Remove the top mounting cover. Undo the safety steel sling and luminaire connector from the top mounting cover.
- Insert the mains supply cable through the top mounting cover. Secure the top mounting cover on the desired ceiling or wall location.
- Wire the luminaire to the mains.
- Connect the luminaire with the connector and secure the luminaire safety steel sling to the top mounting cover.
- Secure the luminaire to the top mounting cover with the supplied screws.
- Test the installation in accordance with wiring rules and regulations. Switch ON the main power.
Replacing the decal
- Remove the side and bottom trim by pulling it outwards. Peel the decal off from the fitting.
- Remove and replace the desired decal.
- Install the side and bottom trims.
Information and data listed in this installation guide is subject to change. Visit our website for up-to-date information.
For more information
www.haneco.com.au
1300 001 LED (533)
Documents / Resources
|
HANECO ESD40M-SM Lighting Emergency LED
Exit
[pdf] Installation Guide
ESD40M-SM, Lighting Emergency LED Exit, Emergency LED Exit, Lighting LED Exit,
LED Exit, Exit
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>