alza G21 Digital safe Instructions
- July 12, 2024
- alza
Table of Contents
G21 Digital safe
Manual
Digital safe G21
Thank you for purchasing our product.
Before using this unit, please read this manual in order to avoid improper
handling and use
of the device.
You have just made an important step to protect your property. Each of our
safes is professionally
produced and ensures the greatest possible security. Before using read
carefully the instructions
on the following pages of this manual.
! PLEASE KEEP THE KEY IN A SAFE PLACE
First use
Method one:
• Find the accessories bag in the package and take out the emergency keys.
• Remove the battery cover, the key hole is on the right side of the battery
box.
• Insert the emergency key into the key hole, rotate the key anti-clockwise
and the knob clockwise
to open the door.
Method two:
• Find the accessories bag in the package, take out four AAA batteries and put
them in the battery
box.
• The safe should have electricity now, input preset user code “159” to open
the door. Every time
you press the number, yellow light will flash once with one beep. If the code
is correct, green light
flashes for 6 seconds with two beeps.
• Rotate the knob clockwise and open the door within 6 seconds of entering the
code.
WARNING: take care about the right polarity of inserted batteries. If
there is a failure of the voltage
supply longer than 3 minutes, the safe will be reset and it is necessary to
proceed according to
“First use” chapter.
Set the user code
Find the green reset button on the back of the safe door. Press it, yellow
light will flash twice with
two beeps.
Enter new user code with 3-8 digits immediately and press “#” to confirm.
If set successfully, yellow light will flash twice with two beeps.
Set the master code
With the door unlocked, input “00” and press the reset button. Start setting
the master code when
yellow light goes on.
Input new master code with 3-8 digits and press “#” to confirm. The code is
set successfully when
yellow light flashes twice with two beeps.
If the light flashes with three beeps, the code change was not effective and
you need to try again.
Open the door
1. Enter the 3-8 digit user code and press “#”. If it is correct, green light
will flash for 6 seconds
with two beeps. Turn the knob clockwise to open the door.
2. Enter the preset password “159” and press “#”. If it is correct, green
light will flash for 6 seconds
with two beeps. Turn the knob clockwise to open the door.
CAUTION: Entering wrong code leads to yellow light flashing three times
with three beeps.
Close the door
Turn the knob anticlockwise to close the door.
Automatic lock
Three continuously wrong entries will activate the warning beeps for 20
seconds.
Another three continuously wrong entries will active the warning beeps for 5
minutes.
CAUTION: The keypad would be disabled during the beeping. You can only
stops the beeps by
opening the safe with emergency keys and power-cut by removing the batteries.
UNDERVOLTAGE WARNING
If the battery power is lower than 4.5 V, red light flashes during operation.
Batteries should be
replaced immediately to ensure normal use.
Mounting process
Put the safe to a place that cannot be easily manipulated.
Drill holes for the dowels.
Turn in expansion screws counterclockwise.
Fix the safe on the wall using expansion or clamping screws.
Make sure the safe is correctly attached to the dowels and tight.
WARNING: Use expansion screws for concrete walls and clamping screws for
wooden walls.
The English version of the manual is an exact translation of the original
manufacturer‘s instructions.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>