VRTEK AVR1 Wireless Android Controller User Manual
- June 25, 2024
- VRTEK
Table of Contents
VRTEK AVR1 Wireless Android Controller User Manual
SETUP
- Plug the wireless receiver into the VR headset’s USB input.
- Press [N icon] to power on the controller.
- A flashing blue LED signals that the controller is on and automatically searching.
- When connected, the blue LED will stop flashing and remain on.
FUNCTIONS
A
- Back
N
- Menu/Power On (Press)
- Calibrate & Sync (Hold for 1 second)
- Power Off (Hold for 5 seconds)
Touch Panel
- Select/Confirm (Press)
- Move Left/Right/Up/Down
- (Touch-sensitive)
Volume +/-
- Volume Up (Press)
- Volume Down (Press)
Micro USB Port
- Charging & Port
Blue LED Light
- Connection & Power Status
- Indicator
FCC statements
The device has been evaluated to meet general RF exposure requirements, The device can be used in portable exposure conditions without restriction Federal Communication Commission (FCC) Radiation Exposure Statement Power is so low that no RF exposure calculation is needed. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications or changes to this
equipment. Such modifications or changes could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Download PDF:VRTEK AVR1 Wireless Android Controller User Manual
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>