SOLIGHT WO8007 LED Lighting with Remote Control Instruction Manual
- July 4, 2024
- Solight
Table of Contents
SOLIGHT WO8007 LED Lighting with Remote Control
Dear customer, thank you for purchasing our product. Please read the following instructions carefully and follow them to serve you safely and to your full satisfaction. This will prevent misuse or damage. Avoid unprofessional handling of this appliance and always observe the electrical appliance usage guidelines. Do not hang or cover the luminaire with anything. Keep the instruction manual carefully. Installation must only be carried out by qualified personnel.
Specifications
- Voltage: EN WO8007 | WO8008
- Consumption: LED lighting with remote control Woody
- Luminous flux: Variable (3000K – 6000K)
- Chromaticity Coverage: Adjustable
- LED lifetime: Not replaceable, entire luminaire replacement required
- Dimensions: As per product design
- Operating temperature: Refer to user manual for details
Installation
- Switch off the power supply before installation.
- Insert dowels into pre-drilled holes.
- Remove the rear of the luminaire and thread the supply cable through the hole.
- Screw on the back of the luminaire.
- Connect the supply cable to the terminal block ensuring correct connection.
- Attach the front of the luminaire to the rear. Switch on the power supply.
Remote Control Usage
- On/Off: Power control
- Brightness +/-: Adjust brightness levels
- Chromaticity +/-: Adjust color temperature
- Night lighting: Activate night light mode
- Brightness levels: 20%, 50%, 100%
- Colour temperature: Options for 3000K, 4000K, 6000K
The light source of this luminaire is non-replaceable, at the end of its service life the entire luminaire must be replaced and disposed of in a designated place. This product contains a light source that for design reasons cannot be removed for verification and therefore the entire product is considered a light source. The manufacturer is not liable for any damage caused by improper use. The product has been issued with a CE declaration of conformity in accordance with the applicable regulations. On request from the manufacturer: info@solight.cz, or downloadable from www.solight.cz/en.
TECHNICAL PARAMETERS
Solight Holding, s.r.o., Na Brně 1972, Hradec Králové 500 06, Czech Republic
FAQ
Q: Can I replace the light source in this luminaire?
A: No, the light source is non-replaceable. The entire luminaire must
be replaced at the end of its service life.
Q: What should I do if the product is damaged due to improper use?
A: The manufacturer is not liable for any damage caused by improper
use. Follow installation and usage guidelines carefully to prevent damage.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>