LED WORLD SF10BB-2G Clear Dice Strip to Strip Connector Instructions
- June 12, 2024
- LED WORLD
Table of Contents
LED WORLD SF10BB-2G Clear Dice Strip to Strip Connector
Product Information
The Clear Dice Strip to Strip Connector SF10BB-2G is a connector designed for use with LED World’s type A (IP20) 12VDC and 24VDC 10mm wide LED Flex Strips. It is used to connect two LED strips together, allowing for extended lighting installations. The connector is suitable for indoor dry location use and should only be used with a Class 2 power supply.
Important Note: This connector should not be used with Type B or C LED
strips that have covers or coatings.
CAUTION: The connector has a maximum current rating of 3 Amps and is
compatible with 12/24VDC (low voltage) systems.
Product Usage Instructions
- Ensure that you have a 10mm wide LED strip and the Clear Dice Strip to Strip Connector SF10BB-2G.
- Unscrew the terminal screws of the connector to prepare for connection.
- Gently insert the 10mm wide LED strip into the connector, making sure that the contact points on the connector align directly over and are centered on the LED strip’s connector pads.
- Hand tighten the terminal screws of the connector, ensuring a secure connection without over-tightening that may damage the LED strip’s PCB.
- Verify that the connection is correct by checking the polarity. The positive (+) and negative (-) terminals on the connector should align with the corresponding terminals on the LED strip.
- Repeat steps 2-5 if you need to connect additional LED strips.
For any further assistance or inquiries, please contact LED World Inc. at 1-800-387-4081 or visit their website at www.ledworldlighting.com or www.ledworld.ca.
IMPORTANT
CAUTION: Max 3 Amps 12/24VDC (low voltage). Use only with Class 2 power
supply. Indoor dry location use.
ATTENTION: Utiliser seulement avec la classe 2 bloc d’alimentation.
For use only with LED World’s type A (IP20) 12VDC and 24VDC 10mm wide LED Flex Strips. Not to be used with Type B or C (Strips that have covers or coatings).
Important Note: Check the Polarity and make sure that connector contact
points are directly over (and centered) the LED Flex Strip connector pads. Do
not connect LED strips at soldered contact points.
INSTALLATION
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA |
Version 1.0 – 07/13/2023
Copyright @2023 LED WORLD INC™. All Rights Reserved. We are not responsible
for errors or omissions. Product and specifications subject to change without
notice. Registered trademarks are owned by their respective registers, or
licensee(s).
ledworldlighting.com |
ledworld.ca
1-800-387-4081
References
- LED World Canada - A Commercial LED lighting supplier
- LED World Lighting - A Commercial LED lighting supplier
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>