SOLIGHT WO813 LED Outdoor Wall Lighting Terni Instructions
- June 1, 2024
- Solight
Table of Contents
WO813
LED outdoor wall lighting Terni
Thank you for purchasing our Terni outdoor wall lighting equipment. The device
has an adjustable PIR sensor. The device is suitable for installation on
outdoor walls as well as indoors. Before installing and using the device,
please read this manual carefully and pay attention to the safety warnings and
instructions. This will ensure not only the protection of persons, but also
the long-term viability of the equipment. Do not repair or modify the
equipment, installation must only be carried out by a qualified technician.
The operating temperature of the equipment is between -20°C and 50°C.
Technical parameters
| W0813
---|---
Power| 220-240V AC
Consumption| 12W
Luminous flux| 5601m
Chromaticity| 3000K
Colour rendering index Ra| >80
Degree of protection| IP 44
Dimensions| 125 x 85 x 135 mm
Installation
Disconnect the power supply before installation!
- Unscrew the side screws on the bottom and top of the device.
- Remove the metal cover and slide the luminaire base plate out of the light-permeable cover.
- Push the supply cable through the rubber hole in the base plate. (If the cable cannot be pushed through, make a thin hole in the rubber seal.) Insert dowels into the pre-drilled holes and screw the base plate into the selected location.
- Connect the supply cable to the terminal board and ensure that the connection is correct! (Refer to the terminal block for wiring markings)
- Place the light-permeable cover on the base plate and then the metal cover.
- Screw in the screws on the top and bottom of the unit.
Safety warning
- Installation may only be carried out by a qualified worker.
- Do not cover the luminaire with anything or hang anything on it.
- Do not repair or modify the equipment in any way.
PIR sensor
The most suitable placement of the device is up to a height of 2.2m. Under
these conditions, the sensor will sense people up to 7m away. For the sensor
to work properly, position it so that people walk past the sensor, not towards
it (see Figure 1)
The detection angle of the sensor can be adjusted by means of a slider, which
is able to coverup to half of the sensor area (see Figure 2).
Adjust the sensor sensitivity by turning the dial on the left side.
You can adjust the duration of illumination (min. 5s | max. 5 min) after
motion detection by turning the wheel on the right side (see Figure3)
The light source of this luminaire is non-replaceable, at the end of its
service life the entire luminaire must be replaced and disposed of in a
designated place. This product contains a light source that for design reasons
cannot be removed for verification and therefore the entire product is
considered a light source.
Solight Holding, s.r.o., Na Brně 1972, Hradec Králové 500 06, Česká republika.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>