WO799-1-B Solight LED Lighting with Remote Control Instruction Manual

WO799-1-B Solight LED Lighting with Remote Control

INTRODUCTION

Dear customer, thank you for purchasing our product. Please read the following instructions carefully and follow them to serve you safely and to your full satisfaction. This will prevent misuse or damage. Avoid unprofessional handling of this appliance and always observe the electrical appliance usage guidelines. Do not hang or cover the luminaire with anything. Keep the instruction manual carefully. Installation may only be carried out by a qualified worker qualified in accordance with Decree No 50/1978 Coll., as amended, at least a worker who is knowledgeable in accordance with § 5 of Decree No 50/1978 Coll., as amended.

TECHNICAL PARAMETERS

PACKAGING CONTENT

• 1x

• 2x

REMOTE CONTROL

1. Turn on
2. Turn off
3. Color temperature change (-)
4. Color temperature change (+)
5. Increase brightness
6. Brightness reduction
7. Brightness at 50%
8. Brightness at 100%
9. Color temperature change
10.  After 60 seconds, it switches off
11. Night mode (brightness 20%)
12. Pairing button

INSTALLATION

Disconnect the power supply before installation.

1. Insert the dowels into the pre-drilled holes.
2. Thread the power cable through the holder and screw the holder in place.
3. Thread the power cable through the hole in the luminaire.
4. Screw the luminaire to the bracket.
5. Connect the power cord to the terminal block and make sure the wiring is correct.
6. Attach the front cover.
7. Switch on the power supply.
   

Note: Use caution when removing the front cover. Press the cover down on one side and lift it up on the other side to remove. You can use a blunt object such as a knife.

Note: To pair the remote control with the light, switch off the light from the mains for approx. 15sec and when the light comes back on, hold the centre button with the WiFi symbol on the remote control (point 12 in the description of the remote control). After successful pairing, the light will flash twice.

CUSTOMER SUPPORT

The light source of this luminaire is non-replaceable, at the end of its service life the entire luminaire must be replaced and disposed of in a designated place. This product contains a light source that for design reasons cannot be removed for verification and therefore the entire product is considered a light source. The power cord cannot be replaced if damaged, the unit

We are not liable for any damage caused by improper use.

Producer:

Solight Holding, s.r.o., Na Brně 1972,
Hradec Králové 500 06, Česká republika.

IP20

Documents / Resources

| SOLIGHT WO799-1-B Solight LED Lighting with Remote Control [pdf] Instruction Manual
WO799-1-B Solight LED Lighting with Remote Control, WO799-1-B, Solight LED Lighting with Remote Control, LED Lighting with Remote Control, Lighting with Remote Control, Remote Control
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>