WO801-B-1 Solight LED Outdoor Wall Light Parma Instruction Manual

WO801-B-1 Solight LED Outdoor Wall Light Parma

Product Information

Specifications:

• Model: WO801-B-1
• Power Consumption: 6W
• Input Voltage: 220-240V AC
• Luminous Flux: 420lm
• IP Rating: IP54
• Dimensions: 100 x 100 x 100 mm

Product Usage Instructions

Installation:

1. Switch off the power supply before installation.
2. Unscrew the side screws.
3. Remove the back plate.
4. Insert the dowels into the pre-drilled holes.
5. Thread the supply cable through the hole in the back plate.
6. Screw the back plate to the wall.
7. Connect the supply cable to the terminal block, ensuring the correct connection.
8. Fit the front of the luminaire to the back plate.
9. Screw in the side screws.

Note: The light source of this luminaire is non-replaceable. At the end of its service life, the entire luminaire must be replaced and disposed of in a designated place. luminaire The product contains a light source that cannot be removed for verification due to design reasons; therefore, the entire product is considered a light source.

FAQ:

• Q: Can I replace the light source in this luminaire?
  A: No, the light source is non-replaceable. The entire luminaire must be replaced at the end of its service life.

• Q: What should I do if I encounter a problem during installation?
  A: If you face any issues during installation, please contact our customer support for assistance. Do not attempt to repair or modify the equipment on your own.

Thank you for purchasing our product. Please read this manual carefully and heed the safety warnings and instructions before installing, using or repairing the equipment. This will ensure not only the protection of persons, but also the long life of the equipment.

TECHNICAL

• Model: WO801-B-1.
• Power: 6W.
• Voltage: 220-240V AC.
• luminous flux: 420lm.
• Protection IP: IP54.
• Dimensions: 100 x 100 x 100 mm.

INSTALLATION

WARNING

1. Installation may only be carried out by a worker with a qualification.
2. Do not cover the luminaire with anything or hang anything on it.
3. Do not repair or modify the equipment in any way.

INSTALLATION

Switch off the power supply before installation!

1. Unscrew the side screws.
2. Remove the back plate.
3. Insert the dowels into the pre-drilled holes.
4. Thread the supply cable through the hole in the back plate.
5. Screw the back plate to the wall.
6. Connect the supply cable to the terminal block, making sure the connection is correct.
7. Fit the front of the luminaire to the back plate.
8. Screw in the side screws.

The light source of this luminaire is non-replaceable, at the end of its service life the entire luminaire must be replaced and disposed of in a designated place. This product contains a light source that for design reasons cannot be removed for verification and therefore the entire product is considered a light source.

Producer: Solight Holding, s.r.o., Na Brně 1972, Hradec Králové 500 06, Česká republika.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>