AViANCE Lighting HD56084 Outdoor Hardwired Wall Lantern Sconce Installation Guide
- July 4, 2024
- AViANCE lighting
Table of Contents
AViANCE Lighting HD56084 Outdoor Hardwired Wall Lantern Sconce
Product Information
Specifications:
- Model: HD56084
- Manufacturer: AVIANCE
- Power Source: Electrical
- Usage: Indoor Lighting Fixture
Product Usage Instructions
Assembling & Installation:
- Shut off the power at the circuit breaker and remove the old fixture, including the single bar.
- Carefully unpack your new fixture and lay out all the parts on a clear surface near the junction box.
- Connect the electrical wires as follows:
- Connect the Black wire from the fixture to the black house (hot) wire.
- Connect the white wire from the fixture to the white (neutral) house wire.
- If your outlet box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the single bar.
- Tuck the wire connections neatly into the wall junction box.
- Return power to the junction box and test the fixture.
FAQ
-
Q: What should I do if my outlet box does not have a ground wire?
A: In that case, you should attach the bare copper fixture wire to the green ground screw on the single bar. -
Q: How can I get assistance with parts or assembly?
A: Please email customer service at info@aviancelighting.net for help with any parts or assembly inquiries.
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the
installation instructions do apply to this product.
WARNING!
SHUT THE POWER OFF AT THE FUSE OR CIRCUIT BREAKER.
ASSEMBLING THE FIXTURE
ASSEMBLING THE FIXTURE (Fig.1)
- Shut off the power at the circuit breaker and remove the old fixture, including the single bar.
- Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to lose any small parts necessary for installation.
- Thread the pipe screw part way into the centre hole of the single bar and secure it with a hex nut.
- Attach the single bar to the junction box using two box screws as shown. The side of the single bar marked “GND” must face out. The junction box is not included.
- Follow wiring instructions carefully (see fig.2).
- Place the lamp body over the pipe screw then tighten it with the ball nut.
- Install the light bulb(Not included) according to the fixture’s specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
- With silicone caulking compound, caulk completely around where the back of the cover meets with the wall surface to prevent water from seeping into the outlet box.
CONNECTING THE WIRES
CONNECTING THE WIRES (Fig.2)
- Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has ground wires (green or bare copper) connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the single bar.
- Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction box and test the fixture.
Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service at:
info@aviancelighting.net.
©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING, INC.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>