AVIANCE Lighting HD59382 1 Light Satin Brass Outdoor Wall Lantern Sconce Instruction Manual
- July 3, 2024
- AViANCE lighting
Table of Contents
AVIANCE Lighting HD59382 1 Light Satin Brass Outdoor Wall Lantern Sconce
Product Information
Specifications
- Model: HD59382
- Brand: AVIANCE
- Type: Fixture
- Ground Wire: Bare Copper
- Color: Black and White
Product Usage Instructions
Assembling & Installation Instructions
The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
Assembling the Fixture (Fig.1)
- Shut off the power at the circuit breaker box.
- Remove the old fixture.
Connecting the Wires (Fig.2)
- Connect the electrical wires as follows:
- Connect the Black wire from the fixture to the black house (hot) Wire.
- Connect the white wire from the fixture to the white (neutral) house wire.
- Make sure all wire nuts are secured.
- You may wrap the connections with electrical tape.
- If your outlet box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
- Tuck the wire connections neatly into the wall junction box.
Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service at: info@aviancelighting.net
Your installation is now complete. Return power to the junction box and the
fixture.
DOC202404HD59382
FAQ
- Q: What should I do if I encounter difficulties during installation?
A: If you encounter any difficulties during installation, please contact our customer service for assistance.
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the
installation instructions do apply to this product. HD59382
WARNING! SHUT THE POWER OFF AT THE FUSE OR CIRCUIT BREAKER.
Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service at:
info@aviancelighting.net
ASSEMBLING THE FIXTURE
- Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
- Thread the pipe screw part way into the center hole of the single bar and secure it with a hex nut. Attach the single bar to the junction box using two box screws. The side of the single bar marked “GND” must face out. The junction box is not included.
- Follow wiring instructions carefully(see fig.2).
- Attach the lamp body onto the junction box, aligning screws on a single bar with a mounting hole, and lock it securely with the ball nut.
- Install the light bulb(not included) according to the fixture’s specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
- With silicone caulking compound, caulk completely around where the back of the cover meets with the wall surface to prevent water from seeping into the outlet box.
CONNECTING THE WIRES
- Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has ground wires (green or bare copper) connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
- Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction box the
fixture.
©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING,INC
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>