AVIANCE lighting HD52116 Fixture 22 Inch 3 Light Brushed Nickel Cast Brass Hardwired Instruction Manual

Table of Contents

Brass Hardwired

AVIANCE-lighting-HD52116--22-Inch-3-Light-Brushed-Nickel-Cast-Brass-
Hardwired-PRODUCT

Assembling the Fixture:

Shut off the power at the circuit breaker and remove the old fixture, including the single bar.
Unpack the new fixture carefully and lay out all parts in a clear area, ensuring not to lose any small parts required for installation.
Place the candle sleeve over the lamp holder.
Install light bulbs (not included) according to the fixture’s specifications. Do not exceed the maximum wattage rating.
Attach the pipe thread into the shade of the lamp body, aligning the box top centre screw hole with the pipe thread. Securely attach the cove to the lamp body and lock it with the loop.
Attach the assembled lamp body onto the post (not included) and secure it with screws.

Connecting the Wires:

Connect the electrical wires as follows: Black wire from \fixture to black house (hot) wire, white wire from fixture to white (neutral) house wire. Ensure all wire nuts are secured and consider wrapping connections with electrical tape. Connect fixture’s ground wire to ground wires or green/bare copper screw as appropriate.
Tuck the wire connections neatly into the post.

Q: Where can I get assistance with parts or assembly?

A: For assistance with parts or assembly, please email customer service at info@aviancelighting.net.

The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.

ASSEMBLING THE FIXTURE (Fig.1)

Shut off the power at the circuit breaker and remove the old fixture, including the single bar.
Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
Put the candle sleeve(G) over the lamp holder.
Install the light bulbs (not included) in accordance with the fixture’s specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
Attach the pipe thread(C) into the shade of the lamp body(D), aligning the box top centre screw hole with the pipe thread, by turning it clockwise until tight. Attach the cove (B) to the lamp body(D), then lock it securely with the loop(A).
Attach the assembly lamp body onto the post (F, no included) and lock it securely with the screws (E).

CONNECTING THE WIRES (Fig.2)

Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has ground wires (green or bare copper) connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
Tuck the wire connections neatly into the post.

Your installation is now complete. Return power to the junction box and test the fixture

Thank you for purchasing an AVIANCE product. Need assistance with parts or assembly? Please email customer service at:info@aviancelighting.net