AVIANCE lighting HD65420 Fixture LED ADA Vanity Light Instruction Manual

Table of Contents

Assembling the Fixture :

Shut off power at the circuit breaker box and remove old fixtures and hardware from the Junction Box.
Unpack the new fixture carefully and lay out all parts on a clear area, ensuring no small parts are lost.
Thread mounting screws into the pre-drilled holes on the mounting plate and attach it to the junction box using provided screws.
Guide fixture wires through the center hole of the mounting plate and follow wiring instructions (refer to fig.2).
Attach the back plate of the lamp body onto the junction box and secure it with column nuts.
Install light bulbs according to fixture specifications, making sure not to exceed the maximum wattage rating.

Connecting the Wires:

Connect Black wire from fixture to black house wire and White wire from fixture to white house wire. Secure connections with wire nuts and electrical tape if needed.
If there are ground wires in the outlet box, connect the fixture’s ground wire to it; otherwise, attach bare copper fixture wire to the green ground screw on the mounting plate.
Tuck wire connections neatly into the wall junction box.

Your installation is now complete. Restore power to the junction box and test the fixture. Thank you for choosing AVIANCE.

FAQ :

Q: What should I do if I encounter any issues during installation?
- A: For assistance with parts or assembly, please email customer service at info@aviancelighting.net with your query and product details.

The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.

WARNING! SHUT THE POWER OFF AT THE FUSE OR CIRCUIT BREAKER.

AVIANCE-lighting-HD65420-Fixture-LED-ADA-Vanity-Light-
FIG1

Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
Thread the two mounting screws about 1/4” into the pre-drilled holes in the mounting plate, spaced about the same distance apart as the holes in the fixture back plate. Attach the mounting plate to the junction box using two junction box screws as shown. The side of the single bar marked “GND” must face out. The junction box is not included.
Guide fixture wires through the hole in the center of the mounting plate. Follow wiring instructions carefully ( see Fig. 2 ) \
Attach the back plate of the lamp body(A) onto the junction box, aligning the back plate’s hole with the mounting screw and lock it securely with the columnists (B).
Install the light bulbs(Not included) in accordance with the fixture’s specifications. DO NOT EXCEED THE MAXIMUM WATTAGE RATING!

AVIANCE-lighting-HD65420-Fixture-LED-ADA-Vanity-Light-
FIG2

Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has ground wires (green or bare copper) connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
Tuck the wire connections neatly into the wall junction box.

Thank you for purchasing an AVIANCE product.

Need assistance with parts or assembly?

Please email customer service at :info@aviancelighting.net