AVIANCE lighting HD79748 Fixture 5 Light Modern Kitchen Island Pendant Light Instruction Manual
- July 4, 2024
- AViANCE lighting
Table of Contents
AVIANCE lighting HD79748 Fixture 5 Light Modern Kitchen Island Pendant
Light
Product Information
Specifications
- Model: HD79748
- Power Source: Electric
- Fixture Type: Ceiling Light
- Bulb Requirement: Not included, follow fixture’s specifications
- Power Off Warning: Shut the power off at the fuse or circuit breaker
Product Usage Instructions
Assembling & Installation Instructions
- Shut off the power at the circuit breaker box and remove old fixtures and hardware from the Junction Box.
- Unpack the new fixture and lay out all parts, ensuring not to lose any small parts needed for installation.
- Thread the pipe screw part way into the center hole of the single bar and secure it with a hex nut.
- Attach the single bar to the junction box using two box screws, ensuring the side marked GND faces out. Connect the electrical wires as shown in Fig.2, making sure the wire nuts are secured. Connect fixture ground wire to outlet ground wire or mounting strap.
- Raise the lamp body onto the junction box, align the pipe screw with the center hole in the plate, and lock securely with the ball nut.
- Install light bulbs according to the fixture’s specifications. Do not exceed the specified wattage.=
WARNING
SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION
COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR
MOUNTING THE FIXTURE
- Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
- Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to lose any small parts necessary for installation.
- Thread the pipe screw part way into the center hole of the single bar and secure it with a hex nut.
- Attach the single bar to the junction box using two box screws as shown. The side of the single bar marked “GND” must face out. The junction box is not included.
- While holding the lamp body towards the ceiling, connect the electrical wires as Shown in Fig.2, making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise, connect fixture’sground wire directly to the Mounting strap with the green screw provided. After wires are connected, tuck them carefully inside the Junction Box.
- Raise the lamp body onto the junction box, aligning the pipe screw on the single bar with the center hole in the plate, and lock it securely with the ball nut.
- Install the light bulbs(not included) by the fixture’s
specifications.
NOTE: DO NOT EXCEED THE SPECIFIEDWATTAGE!
Your installation is now complete. Return power to the junction box and test the fixture
FIG.1
FIG.3
Thank you for purchasing an AVIANCE product. Need assistance with parts or assembly? Please email customer service at:info@aviancelighting.net
FAQ
Q: What should I do if I have trouble with the assembly or parts?
A: For assistance with parts or assembly, please email customer service at:
info@aviancelighting.net
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>