AVIANCE lighting HD56138 12.75 Inch 1 Light Bronze Outdoor Hardwired Wall Lantern Instruction Manual
- July 3, 2024
- AViANCE lighting
Table of Contents
HD56138 12.75 Inch 1 Light Bronze Outdoor
Hardwired Wall Lantern
Instruction Manual
ASSEMBLING & INST A LLA TION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product. HD56138
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
-
Shut off the power at the circuit breaker and remove old fixture, including the single bar.
-
Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
-
Thread the pipe screw part way into the center hole of the single bar and secure with hex nut.
-
Attach the single bar to the junction box using two box screws as shown. The side of the single bar marked “GND” must face out. The junction box is not included.
-
Follow wiring instructions carefully (see fig.2).
-
Place the lamp body over the pipe screw then tighten it with the ball nut.
-
Install the light bulb(Not included) in accordance with the fixture’s specifications.
NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING! -
With silicone caulking compound, caulk completely around where back of cover meets with the wall surface to prevent water from seeping into outlet box.
CONNECTING THE WIRES (Fig.2)
- Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has a ground wires (green or bare copper) connect fixture’s ground wire to it. Otherwise attach the bare copper fixture wire to the green ground screw on the single bar.
- Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction box and test the fixture.
Thank you for purch asingan AVIANCE product.
Nee dassis ance with parts or assembly ? Please email customer service
at:info@aviancelighting.net
©COPY RIGHT ALL RIGHTS RESERVED. AVIANCELIGHTING, INC . DOC 202404 HD56138