AVIANCE HD09110 1 Light Antique Brass Cast Brass Instruction Manual
- July 4, 2024
- AVIANCE
Table of Contents
AVIANCE HD09110 1 Light Antique Brass Cast Brass
Product Specifications
- Model: HD09110
- Fixture Type: Ceiling Light Fixture
- Power Source: Electrical
- Maximum Wattage: Refer to fixture specifications
- Bulb Type: Not included, refer to fixture specifications
- Ground Wire: Included
Product Usage Instructions
Assembling the Fixture
- Shut off the power at the circuit breaker box and remove the old fixture from the Junction Box.
- Unpack the new fixture and lay out all parts, ensuring not to lose any small parts.
- Install the light bulb according to the fixture’s specifications, making sure not to exceed the maximum wattage rating.
- Attach the lamp holder and fixture body as per the provided instructions, securing them with the knob screw.
- Attach the assembly fixture body onto the post (post not included) and secure it with the provided screw.
Connecting the Wires:
Refer to Fig.2 for wire connections:
- Connect Black fixture wire to black house wire (hot).
- Connect White fixture wire to white house wire (neutral).
- If applicable, connect fixture’s ground wire to house ground wire or mounting plate ground screw.
- Secure all wire connections with wire nuts and optionally wrap with electrical tape.
FAQ :
-
Q: What should I do if I have spare parts after installation?
A: If you have spare parts after installation, please store them in a safe place in case they are needed for future maintenance or replacements. -
Q: Can I use a higher wattage bulb than specified?
A: No, it is important not to exceed the maximum wattage rating specified for the fixture to prevent damage or hazards. -
Q: What should I do if I encounter difficulties during installation?
A: If you encounter any difficulties during installation, please contact customer service at info@aviancelighting.net for assistance.
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the
installation instructions do apply to this product.
HD09110
- WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
- ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE
- Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
- Install the light bulb (Not included) in accordance with the fixture’s specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
- Attach the lamp holder (B) insert the fixture body (A), aligning the side hole with the screw hole of the lamp holder (B), then lock it securely with the knob screw (C).
- Attach the assembly fixture body onto the post (E, Not included) and lock it securely with the screw (D).
CONNECTING THE WIRES
- Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has a ground wires (green or bare copper) connect fixture’s ground wire to it. Otherwise attach the bare copper fixture wire to the green ground screw on the mounting plate.
- Tuck the wire connections neatly into the post.
Your installation is now complete. Return power to the junction box
Thank you for purchasing an AVIANCE product. Need assistance with parts or assembly? Please email customer service at:info@aviancelighting.net©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING,INC.