AVIANCE Lighting HD09363 11.25 Inch 1-Light Flemish Brass Outdoor Hardwired Wall Lantern Sconce Installation Guide
- July 3, 2024
- AViANCE lighting
Table of Contents
AVIANCE Lighting HD09363 11.25 Inch 1-Light Flemish Brass Outdoor
Hardwired Wall Lantern Sconce
Product Specifications
- Model: HD09363
- Brand: AVIANCE
- Power Source: Hardwired
- Fixture Type: Ceiling Light Fixture
The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.
FAQ
- Q: What should I do if my fixture does not exactly match the drawing provided?
- A: The installation instructions provided are applicable even if there is a discrepancy in the visual representation of the product.
- Q: How can I get assistance with parts or assembly?
- A: For assistance with parts or assembly, please email customer service at info@aviancelighting.net.
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ASSEMBLING THE FIXTURE
ASSEMBLING THE FIXTURE (Fig.1)
- Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
- Thread the pipe screw part way into the center hole of the single bar and secure with hex nut. Attach the single bar to the junction box using two box screws. The side of the single bar marked “GND” must face out. The junction box is not included.
- Follow wiring instructions carefully(see fig.2).
- Attach the lamp body(A) onto the junction box, aligning screws on single bar with mounting holes and lock it securely with the ball nuts(B).
- Install the light bulb(not included) in accordance with the fixture’s specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
- With silicone caulking compound, caulk completely around where back of cover meets with the wall surface to prevent water from seeping into outlet box.
CONNECTING THE WIRES
CONNECTING THE WIRES (Fig.2)
- Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has a ground wires (green or bare copper) connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
- Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction box the fixture.
Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service at:
info@aviancelighting.net
©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING,INC.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>