AVIANCE Lighting HD68100 16 Inch 1-Light Black Outdoor Hardwired Wall Lantern Sconce Installation Guide
- July 3, 2024
- AViANCE lighting
Table of Contents
- AVIANCE Lighting HD68100 16 Inch 1-Light Black Outdoor Hardwired Wall
- Thank you for purchasing an AVIANCE product.
- MOUNTING THE FIXTURE (Fig.1)
- 8.With silicone caulking compound, caulk completely around where back of
- CONNECTING THE WIRES (Fig.2)
- Re ad More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
AVIANCE Lighting HD68100 16 Inch 1-Light Black Outdoor Hardwired Wall
Lantern Sconce Installation Guide
Your installation is now complete. Return power to the junction box and test the fixture.
Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service at:info@aviancelighting.net
- WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT
- ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN
MOUNTING THE FIXTURE (Fig.1)
- Shut off the power at the circuit breaker Remove old fixture and all hardware from Junction Box.
- Carefully unpack your new fixture and lay out all the parts on a clear Take care not to lose any small parts necessary for installation.
- By measuring the both end holes distance of the mounting plate, drill holes in the wall, then loaded plastic anchors. Attach the mounting plate to the Junction Box with the two Junction Box Screws and four wood screws as shown. The side of the mounting plate marked “GND” must face The junction box is not included.
- Guide fixture wires through hole in center of mounting
- Follow wiring instructions carefully (see 2).
- Raise the lamp body onto the mounting plate, aligning the mounting holes with mounting screws, then lock it securely with the column nuts. Raise the glass insert to the lamp holder, by turn it clockwise until tight.
- Install the light bulb (not included) in accordance with the fixture’s NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
8.With silicone caulking compound, caulk completely around where back of
cover meets with the wall surface to prevent water from seeping into outlet box.
CONNECTING THE WIRES (Fig.2)
-
Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has a ground wires (green or bare copper) connect fixture’s ground wire to it. Otherwise attach the bare copper fixture wire to the green ground screw on the mounting
-
Tuck the wire connections neatly into the wall junction
Re ad More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>