AVIANCE Lighting HD27206 Cresthill 25 Inch 3-Light Black Dimmable Outdoor Pendant Light Installation Guide
- July 3, 2024
- AViANCE lighting
Table of Contents
AVIANCE Lighting HD27206 Cresthill 25 Inch 3-Light Black Dimmable Outdoor
Pendant Light Installation Guide
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.
- WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
- ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.2)
- Put the candle sleeve over the lamp holder .
- Install the light bulbs(Not included) in accordance with the fixture
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
HANGING THE FIXTURE (Fig.1)
- Shut off the power at the circuit breaker and remove old fixture from ceiling, including the old single bar. Shut off the power at the circuit breaker and remove old fixture from ceiling, including the old single
- Carefully unpack new fixture and lay all the parts on a clear
- Thread nipple (C) into loop (F) until
- Thread other end of nipple (C) with loop attached into single bar (D) until
- Place lock washer (B) over end of nipple protruding through single bar and thread hex nut (A) onto nipple until tight.
- Take this single bar assembly and mount to ceiling junction box with junction box screws (E). Tighten screws securely with
- Using proper chain pliers to open one end link of the chain provided and connect to the fixture Close the link.
- By measuring, determine correct number of links needed for proper hanging Using proper chain pliers disconnect and discard remaining chain.
- Lace the fixture wires through the
- Slip loop collar (H) over the chain, then do the same with the canopy (G).
- Open the other end link of the chain and hang the fixture on the loop at the ceiling . Close the
- Feed the fixture wires through the loop (F) and nipple (C) and pull until
CONNECTING THE WIRES (Fig.3)
- Take the black wire from the ceiling junction box and the smooth wire leg from the fixture and twist bare ends together. Twist wire connector onto end of wire until
- Repeat same process with white junction box wire and ribbed wire leg of fixture NOTE: Twist wires together in the same direction you twist the wire connector onto wires.
- If your junction box has a grounding wire (green or bare copper), attach this wire and the bare copper wire from the fixture together as step If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
- Tuck these wire connections neatly into the ceiling outlet box and then raise the canopy (G) all the way to the ceiling. Raise the loop (H) and thread onto ceiling loop protruding through.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>