Enduro Rear Wheel Spacer Kit Instructions
- June 3, 2024
- Enduro
Table of Contents
REAR WHEEL SPACER KIT INSTALLATION INSTRUCTIONS
Rear Wheel Spacer Kit
-
Using a 30mm socket remove the rear axle nut and remove the rear axle. (FIG 1 & 2)
-
Remove the rear wheel from the motorcycle.
-
Remove the rear wheel spacers from the hub of the wheel by grabbing onto the spacer and pulling outward while spinning the spacer. (FIG 3)
-
Replace the spacer removed in step 3 with the Enduro Engineering Wheel spacer. (FIG 4) They are symmetrical and are the same for both sides. Make sure the spacer is pressed in all the way before reinstalling the rear wheel to the motorcycle.
-
Reinstall the rear wheel onto the motorcycle. Slide the axle back through.
-
Reinstall the axle nut and tighten using a 30mm Socket.
-
Have Fun and enjoy your next ride.
WARNING AND DISCLAIMER
All parts manufactured, designed or sold by Enduro Engineering, Inc. (EEI) are
to be installed by a licensed motorcycle dealer or a licensed motorcycle
technician, Motorcycles can be dangerous. Serious injury, death and property
damage can result from the use of motorcycles. This risk is increased by
improper installation or misuse of after marker parts. EEI’s customers must
exercise good judgement in the use, control, alteration, part selection and
installation, and maintenance of their motorcycles. In the event of a possible
defect In material or design, or any other defect in o port manufactured,
designed or sold by EEI, the responsibility of EEI is limited either a refund
of the purchase price or the replacement of the part if EEI determines the
part to be defective, and subject to EEI’s inspection of the part within
thirty 130) days from the date of purchase. (Note: any attempted repairs or
modifications mode to EEI Products will void this limited warranty.) EEI,
under no circumstances will be responsible for incidental and/or consequential
damages, property damage, personal injury damage, or damage, injury, cost or
expense of any kind or nature whatsoever. By purchasing as product or a
product sold by EEI, you (1) acknowledge the above disclaimer and agree to its
terms; (21 agree that any claim brought against EEI arising from and/or
pertaining to or otherwise related to a part manufactured, designed or sold by
EEI must be brought In the Michigan State Courts located in the County of
Ingham or in the Federal District Court for the Western District of Michigan
and the Michigan law shall apply on all issues; and (3) any claim against EEI
must be brought within one (1) year of purchase of the product. EEI makes no
other warranty, express or implied, including without limitation any
warranties of merchantability and fitness for a particular purpose.
REAR WHEEL SPACER KIT INSTALL INSTRUCTIONS PART NUMBER 16-1023
Quality Off-Road Motorcycle Products
enduroeng.com/1517.393.2421)/infouenduroeng.com/infouenduroeng.com)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>