Enduro 27-9013 Sherco Ignition wire Guard Instruction Manual
- June 3, 2024
- Enduro
Table of Contents
Enduro 27-9013 Sherco Ignition wire Guard
INSTALLATION INSTRUCTIONS
- Using an 8mm T-Handle or Socket, remove the two bolts shown in (FIG 1). You will reuse these bolts. Keep track of which one goes where, the further forward bolt is slightly longer.
- Line up the Enduro Engineering Ignition Wire Guard to the two bolt holes you removed in step 1. Using the same bolts removed in step one. Thread them in one at a time and leave loose until both bolts are started. (FIG 2)
- Using an 8mm T-Handle or Socket, tighten both Ignition Wire Guard Bolts. (FIG 3) 4. Have fun and enjoy your next ride.
WARNING AND DISCLAIMER
Al parts manufactured, designed or sold by Enduro Engineering, Inc. (EEl) are to be installed by a licensed motorcycle dealer or a licensed motorcycle technician, Motorcycles can be dangerous. Serious injury, death and property damage can result from the use of motorcycles. This risk is increased by improper installation or misuse of after marker parts. EE!’s customers must exercise good judgement in the use, control, alteration, part selection and installation, and maintenance of their motorcycles. In the event of a possible defect in material or design, or any other defect in a part manufactured, designed or sold by EEl, the responsibility of EEl is limited either a refund of the purchase price or the replacement of the part if EEl determines the part to be defective, and subject to EEl’s inspection of the part within thirty (30) days from the date of purchase. (Note: any attempted repairs or modifications made to EEl Products will void this limited warranty.) EEl, under no circumstances will be responsible for incidental and/or consequential damages, property damage, personal injury damage, or damage, injury, cost or expense of any kind or nature whatsoever. By purchasing as product or a product sold by EEI, you (1) acknowledge the above disclaimer and agree to its terms; (2) agree that any claim brought against EEl arising from and/or pertaining to or otherwise related to a part manufactured, designed or sold by EEl must be brought in the Michigan State Courts Located in the County of Ingham or in the Federal District Court for the Western District of Michigan and the Michigan law shall apply on all issues; and (3) any claim against EEl must be brought within one (1) year of purchase of the product EEI makes no other warranty, express or implied, including without limitation any warranties of merchantability and fitness for a particular purpose.
enduroeng.com// 517.393.2421 /info@enduroeng.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>