concept VP6110 Rod and Hand Held Cordless Vacuum Cleaner Instruction Manual

concept VP6110 Rod and Hand Held Cordless Vacuum Cleaner

Product Specifications

• Power: DC 25.2 V, 380 W
• Noise Level: 80 dB
• Battery Capacity: 2,500 mAh
• Operating Time : 40 minutes
• Charging Time : 4 hours

ACKNOWLEDGMENT
Thank you for purchasing a Concept product. We wish you much joy with your new appliance every day you use it.
Please read the instruction manual carefully before initial use. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance.

Technical specifications

IMPORTANT SAFETY PRECAUTIONS

• Do not use the appliance in any other way than as described in this manual.
• Make sure the mains voltage and current protection correspond to the values on the rating plate of the charging station.
• Do not leave the appliance without supervision when it is turned on.
• When disconnecting the unit from the wall outlet, never pull the power cord, grasp the charger and disconnect it by removing it from the receptacle.
• Do not allow children or unauthorized people to handle the appliance, use it out of their reach.
• Pay extra attention if the appliance is used near children.
• Do not use the appliance as a toy.
• Do not use any accessories other than those recommended by the manufacturer.
• Do not use a charger with a damaged cord or plug and have it repaired immediately by an authorized service centre.
• Keep the appliance away from heat sources such as radiators, ovens and others, and protect it from direct sunlight and humidity.
• Do not touch the appliance with wet hands.
• Do not insert any objects into the openings. Do not use the appliance if any of the openings is clogged.
• Take extra caution when vacuuming on stairs.

Damages from failure to follow the manufacturer’s instructions are not covered by the warranty.

PRODUCT DESCRIPTION

1. Battery
2. Appliance body
3. Dust container
4. Suction tube
5. Large turbo brush
6. Pet brush
7. Slot nozzle
8. Slot nozzle with brush
9. Flexible hose
10. Mini turbo brush
11. Wall bracket
12. Carpet brush
13. Large Hardfloor brush
14. Adapter
15. ON/OFF button
16. Power regulator

DISPLAY DESCRIPTION

• Filter status indicator – If the indicator light comes on, the filters must be cleaned or replaced.
• Dirt indicator light – The indicator light comes on when the appliance detects a large amount of dirt.
• Battery indication – The indicator light indicates the battery status.
• MIN For a small amount of dirt.
• AUTO Automatically adjusts the suction power according to the amount of dirt. If it detects a large amount of dirt, it switches to the MAX mode, if it detects a small amount of dirt, it sets the suction power to MIN.
• MAX Maximum power for a large amount of dirt.

OPERATING INSTRUCTIONS

Vacuum cleaner assembly
Always disconnect the plug out of the electrical outlet before assembling or removing accessories!

1. Insert the suction tube into the hand-held unit of the vacuum cleaner, you will hear a click. To remove the tube from the hand-held unit, press the lock button and pull to disconnect.
2. Insert the turbo brush into the suction tube, you will hear a click. To remove the turbo brush from the extension tube, press the lock button and pull to disconnect. The turbo brush can be connected to the hand-held unit in the same way.

BATTERY INSTALLATION

Insert the battery into the body of the hand-held unit and install it to prevent it from coming loose. The battery is placed correctly when you hear a sound. To release the battery, press the release buttons and pull to disconnect.

Note: To prolong the battery life, always charge the battery when the battery is nearly empty. Do not store or recharge the appliance in an environment with temperatures below 0 °C or higher than 40 °C. These temperatures may damage the appliance. During the charging process, the temperature of the appliance may increase, this is normal. If you do not use the vacuum cleaner for more than 3 months, allow it to charge for 12 hours. Then place the vacuum cleaner in a dry and cool place.

USE
Before installing the battery, check if it is fully charged.

1. Press the ON/OFF button to switch on the appliance.
2. You can use the power regulator to change the appliance mode to MIN, AUTO, MAX.
3. Press the ON/OFF button again to switch off the vacuum cleaner.

Note: We recommend using the maximum power of the hand-held unit in the case of a heavily soiled area or on carpets with medium or high pile.

ACCESSORIES

Select the accessories according to the nature of the surface to be cleaned.

• Mini turbo brush – suitable for bed linen, fabric, sofas, etc.
• Slot nozzle – suitable for wall corners, car cushioning, radiators, etc.
• Slot nozzle with brush – suitable for bed linen, fabric, sofas, etc.

EMPTYING THE DUST CONTAINER
To empty the dust container, press the emptying button. Open the container, empty the dust and close the container cover.

REMOVING THE DUST CONTAINER
Press the buttons to release the dust container and move down and away from the appliance to remove the dust container.

REMOVING THE FILTER
Remove the filters from the dust container upwards. Turn the coarse filter to the left and the HEPA filter to the right to separate the filters. The filters can be rinsed in water. Allow the filters to dry before placing back into the dust container.

REMOVING THE BRUSH
There is a brush release button on the side of the turbo brush, slide the button to release the brush, then the brush can be removed

CHARGING THE APPLIANCE IN THE WALL BRACKET
Before placing the appliance in the wall bracket, remove the battery and connect it to the wall bracket separately, then hang the appliance. Plug the adapter into the wall bracket. After charging, all the bars on the battery will light up.

CHARGING WITHOUT THE WALL BRACKET
Plug the adapter into the charging connector on the appliance handle. After charging, all the bars on the battery will light up.

SERVICE

Extensive maintenance or repair, which requires access to internal parts of the product, has to be performed by a qualified service centre.

ENVIRONMENTAL CONCERNS

• Packaging materials and old appliances should be recycled.
• Packaging materials may be disposed of as sorted waste.
• Dispose of the plastic bags made of polyethylene (PE) as sorted waste.

Recycling of the appliance at the end of its lifespan
This appliance is labelled by European Directive 2012/19/EU concerning used electrical and electronic appliances (Waste Electrical and Electronic Equipment – WEEE). The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead, it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of the product. The disposal of such material has to be done according to the recycling regulations. For more detailed information about recycling of this appliance see the authorized local office or service for household waste disposal or the shop, where you purchased the appliance.

The product meets all the requirements of the EU directives applicable to the specific product.
Changes in text, design, and technical specifications are subject to change without notice and we reserve the right to change them.

WARRANTY TERMS

Warranty

• The manufacturer (or importer) is responsible for ensuring the product complies with the requirements of applicable legal regulations as well as those of the relevant technical standards. Moreover, they are responsible for ensuring the product has the properties the manufacturer described in documents related to the goods or those reasonably expected by the customer about the nature of the goods or based on advertising produced by the manufacturer, and further they are responsible for ensuring the product is fit for the purpose proposed by the manufacturer or that a product of the same type is normally used for.
• The quality warranty term is 24 months from product takeover by the customer.
• The warranty does not apply to wear and tear caused by regular use. The customer shall not be entitled to any warranty claims if, before taking the product over, they knew the product contained a defect or if the defect is attributable to the customer.
• In terms of these warranty conditions, a defective battery is considered a battery that is electronically inoperative (i.e., does not communicate with the base unit, the charging or discharging circuits are defective, etc.) or has an internal short circuit.
• Defects or changes in parameters caused by normal use and wear (e.g. natural capacity decrease) are in no way considered a defect in terms of warranty.
• The battery is provided warranty service for 6 months. In terms of these warranty conditions, the battery has the nature of a consumable, for more details see „Consumables“.

Consumables
For consumables (batteries, etc.) we guarantee the preservation of technical parameters for 6 months, in case it was not damaged by improper use and its lifetime has not expired.

The warranty specifically does not apply:

• if the product installation, operation and service conditions stipulated in the product operating manual have not been adhered to,
• to malfunctions caused due to mechanical, heat or chemical damage, short circuits, over-voltage or incorrect installation,
• to malfunctions caused by an inexpert third-party intervention,
• to malfunctions caused by natural disasters,
• to malfunctions caused by insufficient or inappropriate maintenance in violation of the operating manual, including malfunctions caused by water and other sediments,
• to changes in the colour of the heating surface or to scratching of the surface caused as a result of using the products unusually,
• to appearance and functional changes caused by exposure to sunlight, thermal radiation of water and other sediments, if the service life of certain product parts expires, e.g. for accumulators, bulbs, etc.

The warranty does not apply to any products and services provided along with the product (gifts, promotional articles, etc.).

Filing a complaint

• A complaint against a product defect must be filed as soon as identified, yet no later than before the end of the warranty term.
• The customer must file a product complaint with the dealer from which they have purchased the product, or with any authorised service centre, a list of which is included in the product package, or available at www. my-concept.com.
• While filing a product complaint, the product must be duly cleaned and securely packed to prevent any damage during its transport to an authorised service centre, where relevant, unless the product is delivered in person.
• The customer must submit proof of having concluded a purchase contract for the product by producing the receipt.
• While filing their complaint, the customer must indicate the noted defect and identify the preferred complaint application method.

Complaints processing

• As long as the noted defect may be removed, the user has the right to have the defect duly removed free of charge on a timely basis.
• If the noted defect is not removable, or if the customer becomes entitled to the replacement of the product or a part thereof, yet the replacement is not possible, for example, due to the product having been sold out, the customer has the right to return the product (withdrawal from the contract).
• The customer shall have the right to a new product (replacement) or to replacement of a part of the product even if the defect can be removed, provided they cannot properly use the product due to repeated occurrence of the defect or due to a high number of such defects. In such a case, the customer also has the right to return the product (by withdrawing from the contract).
• If the product is not returned (the customer does not withdraw from the contract), or if the customer does not apply the right to a new defect-free product (replacement), to replacement of a part thereof or to repair of the product, they may request a reasonable discount. The customer also has a right to a reasonable discount if a new defect-free product cannot be supplied to them, or if a product part cannot be replaced or the product repaired unless the situation is remedied within a reasonable time limit, or if remedying the situation would create major discomfort on the part of the customer.

The seller, authorised service centre or a staff member authorised by them must decide about each complaint immediately or within three business days in complicated cases. This term does not include a reasonable period, depending on the type of product concerned, required for the defect to be assessed by an expert. A  complaint, including defect removal, must be dealt with without any undue delay, yet no later than within 30 calendar days of the complaint filing date, unless the seller and the customer agree on a later deadline.

• On returning the product (withdrawing from the contract) the customer must return any accessories and documents supplied along with the product.
• The customer does not have the right to keep the defective parts and components of the product replaced as part of a repair of the product.
• This shall be without prejudice to any other rights the customer may have concerning the purchase of the product.
• Remark: Complaints against products damaged in transport are governed by the carrier’s complaints procedure.

Manufacturer

• ADDRESS: Jindřich Valenta – Concept Vysokomýtská 1800, 565 01 Choceň Czech Republic
• tel.: +420 465 471 400
• fax + 420 465 473 304
• Company ID No. 13216660
• email: servis@my-concept.cz
• www.my-concept.com

Product data

Model:

• Production number
  • Date of purchase: Seal and signature of vendor:

Frequently Asked Questions

• Q: How do I know when to adjust the power mode on the vacuum cleaner?
  • A: The vacuum cleaner automatically adjusts suction power based on dirt levels. For heavily soiled areas, use MAX mode; for light cleaning, MIN mode is suitable.
• Q: Can I charge the vacuum cleaner without using the wall mount?
  • A: Yes, you can charge the vacuum cleaner by connecting the charger directly to the handle’s charging socket.
• Q: How long does it take to fully charge the battery?
  • A: The battery requires 4 hours for a full charge, indicated by a full battery icon on the display.

References

• concept.com
• Concept – chytře vymyšleno pro život
• Domena Concept.pl jest na sprzedaż - SklepDomeny.pl
• Luxury Architecture, Concept Architects, Bratislava
• Elektronika Banjan d.o.o.
• Elektro obchod - servis
• Concept
• my
• Concept
• Concept – chytře vymyšleno pro život
• Concept innowacje w Twoim życiu!
• www.my-concept.sk | vymyslené pre život
• Verners

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>