ROCCAT Kone Pro Iconic Ergonomic Gaming Mouse User Guide
- June 8, 2024
- ROCCAT
Table of Contents
QUICK START GUIDE
PACKAGE CONTAINS
DEFAULT BUTTON ASSIGNMENT
(no driver installed)
STANDARD
- += Left mouse button
- = Right mouse button
- = Universal scroll
- =Scroll up
- = Scroll down
- = IE Forward
- = IE Backward
- = Profile cycle button
- =Connection mode slider (2.4GHz / OFF / Bluetooth®)
- = Dongle storage
QUICK START GUIDE
-
Plug the wireless dongle” into any free USB port on your PC or laptop. Alternatively, enable Bluetoothe.
-
Select 2.4GHz mode on the connection mode slider underneath the mouse to connect via dongle. Alternatively, select Bluetooth’3′ mode to connect via Bluetoothl’.
-
Hold down the profile button for 3 seconds to enable pairing mode. If you’re connecting via dongle, the mouse will be paired automatically.
If you’re connecting via Bluetoothr, you’ll need to pair manually via the Bluetooth” settings in your device.
-
Navigate to www.roccat.org/roccat-swarm and download the latest version of Swarm.
-
Complete the installation to get access to all software features and setup.
DRIVERLESS SETUP
Press the profile button in combination with the left mouse button for three
seconds to enter config mode. The mouse will blink in the color of the active
profile. To exit config mode, press the profile button in combination with the
left mouse button for three seconds once more.
Scroll up/scroll down: Change DPI level from 5 available presets. LEDs will
fade into one of the colors listed below to reflect the chosen DPI preset.
- 400 DPI – red
- 800 DPI – green
- 1200 DPI – cyan
- 1600 – blue
- 3200 – pink
Forward side button/backward side button: Change polling rate. The right mouse button will blink in one of the colors listed below to reflect the chosen polling rate.
- 125Hz – blue
- 250Hz – green
- 500Hz – yellow
- 1000Hz – white [default)
Wheel click: Swap between 1mm and 2mm lift-off dis-tance. The left mouse button will blink in one of the co-lors listed below to reflect the chosen lift-off distance.
- 1mm – red
- 2mm – green
While holding the left mouse button, press forward side button/backward side button: Change LED brightness in steps of 10%. While holding the right mouse button, press forward side button/backward side button: Change between Static, Wave, Heartbeat, Breathing or Blinking RGB modes. The effect is immediately shown on the mouse. While holding the left or right mouse buttons and wheel up/down: Change the color of the LEDs corresponding to the button held from 16 presets. When both are held at the same time it changes both at once. Changes are immediately shown on the mouse.
TECHNICAL FACTS
TECH SPECS KONE PRO AIR
- ROCCATg Owl-Eye 19K dpi optical sensor (based on PixArt PMW3370)
- 400 IPS (10.2m/s) maximum speed
- 40g maximum acceleration (stop to maximum speed in 0.03s required to reach limit)
- Default DPI steps: 400, 800 (default), 1200, 1600, 3200
- 2.4GHz frequency
- Bluetooth® mode
- 450 mAh battery, 100h+ battery life without RGB
- ROCCAT Phantom Flee” USB-C charging cable
- 1000Hz polling rate
- Lift-off distance: 1mm, 2mm and surface calibration
- ARM32 MO+ MCU
- ROCCAT Titan Switch Optical, 100 million click life•cycle
- 75g weight
Should you need assistance … Our support team is ready to help you with any
technical questions. Just send an e-mail to
support@roccat.org or visit our website
at:WWW.ROCCAT.ORG/SUPPORT
SYSTEM REQUIREMENTS
- Windows° 7, 8 and 10 (software support)
- USB 2.0 (or higher)
- Internet connection (for driver software)
Disposal information
**** The crossed-out wheelie-bin symbol means that you must not dispose of
this product toge- ther with unsorted household waste. As electrical devices
can contain harmful substances which may cause environmental damage or harm to
your health if not disposed of correctly, please dispose of these products
separately. As the end user, you are required by law to dispose of used
electrical equipment at an official recycling point. For information about
local recycling points, contact your local authority, civic amenity site or
the business where you purchased this product. By disposing of electrical
products at an official recycling point, you are doing your bit to ensure
equipment is recycled correctly and professionally, and our environment Is
protected.
When purchasing a new product, the retailer will let you hand in old products
and dispose of them free of charge provided the product you are handing in is
of a similar type and has the same functions as the product you are purchasing
You can hand in small used electrical and electronic equipment (measuring no
longer than 25 cm on any one side) for free and with no obligation to purchase
a similar product at electrical and electronic retail outlets with sales areas
larger than 400m? or at nearby recycling points designated by the retail
outlet. Wherever possible, remove any batteries before disposing of the
device. binder law, as a user you face the risk of penalties if you dispose of
devices and batteries illegally.
Technical support
Having technical problems with this product? Get in touch with our Support
team — the quickest way is via our website: www.roccat.org/support
Please keep this information for later reference.
FCC CAUTION:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the users authority to operate this equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference
and (2) this device must accept any interference received, including
Interference that may cause undesired operation. Mouse FCC ID: XGB-K1PA.
Dongle FCC ID: XGB-KIPA-D
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT : This equipment
has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designs to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures: -Reorient or relocate the receiving antenna. -Increase the
separation between the equipment and receiver. -Connect the equipment into an
outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
GENERAL SAFETY GUIDELINES AND INTENDED USE BATTERY SAFETY GUIDEUNES
- Do not open or modify the product.
- Not approved changes or modifications may void the operation chemical damages and injuries. authority and/or warranty.
- In case of trouble or doubt, contact us immediately.
- Do not short-circuit the battery.
- Do not leave the battery discharged or unused for extended time periods
- Improper or incorrect use of the product or use of the product for purposes not recommended by the manufacturer void the liability and/or warranty.
- Don’t look into the light beam on bottom of the mouse.
BATTERY SAFETY GUIDEUNES
- Improperly treated rechargeable batteries may catch fire or cause
- Do not disassemble or modify the battery in any way.
- If battery is damaged or appears abnormal, stop using it.
- Keep the product away from fire/water/humidity/temperature extremes.
- Only use as intended with a compliant PC and connector part.
- If battery is replaceable by design, do not apply higher forces which may damage the battery
- Only use original equipment and cables for charging.
. DC 5V/300 mA I Rated voltage/current: DC 5V / 300 mA I Warning: If the
battery is incorrectly replaced, there Is a danger of explosion. Dispose of
used batteries according to the manufacturer’s instructions.
Hereby Voyetra Turtle Beach Inc. declares that Kone Pro Air is in compliance
with Directive 2014/30/8.1(EMO, Directive 2014/53/EU(RED), 2014/35/EU(Safety),
2015/863 amending Amex II to 2011$5/EC(RoHS), Electromagnetic Compatibility
Regulations 2016(EMC), Radio Equipment Regulations 2017(Radio), Electrical
Equipment Regulations 201B(Safety), 2012/19/EU (WEED, 2006/1907/EU (REAC1-11,
U (PACKAGING), 2006/66/EU (Battery), 2009/48/EC (Toy safety), The Restriction
of the Use of Certain Hazardous Substances in Electrical and Electronic
Equipment Regulations 2012 The full text of the EU/UK declaration of
conformity is available at the following intemet address:
http://Awmturtlebeach.corn/homologation
Radio frequency: 2400MHz
Operating frequency: 24W-2483.5MHz
Output power: 0.035 dBm
RF RADIATION EXPOSURE & HAZARD STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not
co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Industry Canada’s licence-exempt ASSs.
Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
RF RADIATION EXPOSURE & HAZARD STATEMENT
The product complies with Canada portable AF exposure limits set forth for an
uncontrolled environment and are safe for intended operation as described in
this manual. The further RF exposure reduction can be achieved if the product
can be kept as far as possible from the user body or set the device to lower
output power if such function is available.
VOYETRA TURTLE BEACH, INC. | 44 SOUTH BROADWAY, 4TH FLOOR, WHITE PLAINS NY
10601, USA
© 2021 Voyetra Turtle Beach, Inc. All rights reserved. Any product names
mentioned in this manual may be trademarks or registered trademarks and are
the property of their respective owners. Information contained herein is
subject to ghenge without notice. 2021 Voyetra Turtle Beach, Inc shall not be
made liable for any errors that may appear in this manual. This publication or
parts of it may not be reproduced without the express consent of the publisher
Our foods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a mejor failure
and for compensation for anyother reasonably foreseeable loss or damage. You
are also entitled to have the goods repaired or r placed if the goods fail to
be of acceptable quality and the failure does not amount to a major failure.
BSMI | http://bsmi.raccat.org/229
Join the community
Become a ROCCAT member and register your product at: www.roccat.org/support
/register-your-product
Service & support Authenticity check
Easy access to customer support
Make sure you own an original
Exclusive deals Opt-in for special offers and downloads
Please use your product’s serial number (located on the bottom label)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>