ROLL-A-SHADE SelectBlinds Cordless Roller Shade with PVC Valance Installation Guide
- June 27, 2024
- ROLL-A-SHADE
Table of Contents
- Select Blinds Cordless Roller Shade with PVC Valance
- PLUS+ SHADE OPEN ROLL MANUAL INSTALLATION INSTRUCTIONS
- 1 INSIDE OR OUTSIDE APPLICATION
- 2 MOUNTING LOCATION
- 3 SCREW INSTALLATION
- 4 ALIGNMENT
- 5 SHADE PIN END INSTALLATION
- 5 CLUTCH END & TENSION DEVICE INSTALLATION
- 11 COMPLETED INSTALLATION
- INSIDE MOUNT & TENSION DEVICE INSTALLATION
- OUTSIDE MOUNT & TENSION DEVICE INSTALLATION
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Select Blinds Cordless Roller Shade with PVC Valance
PLUS+ SHADE OPEN ROLL MANUAL INSTALLATION INSTRUCTIONS
Rollashade.com
info@rollashade.com
951.245.5077
© Copyright Roll-A-Shade® Inc. All Rights Reserved.
1 INSIDE OR OUTSIDE APPLICATION
NOTE: ALL SHADES MAY BE PRE-PROGRAMMED TO SENSORS, REMOTES, AND/OR WALL SWITCHES UPON ARRIVAL
RASPSORMLVER.3 2 OF 5 | © Copyright Roll-A-Shade® Inc. All Rights Reserved.
2 MOUNTING LOCATION
Place your first bracket in its mounting location and mark the screw holes.
Place your second bracket in its mounting
location and repeat the process.
3 SCREW INSTALLATION
Next, pre-drill your screw holes using a 1/8” drill bit. Install the brackets
with the provided screws using the 1/4” hex
head driver.
4 ALIGNMENT
Check to make sure your brackets are level and aligned.
5 SHADE PIN END INSTALLATION
Depress pin end and slide onto bracket until pin engages in center hole. Press idler shaft all the way to the bracket.
5 CLUTCH END & TENSION DEVICE INSTALLATION
Lineup to clutch bracket. Push clutch into clutch bracket. Install tension device.
11 COMPLETED INSTALLATION
TENSION DEVICE
INSTALLATION INSTRUCTIONS
Rollashade.com
info@rollashade.com
951.245.5077
INSIDE MOUNT & TENSION DEVICE INSTALLATION
Pull the Chainhold down until the chain is fully tensioned (plunger will be fully raised). Screw device into wall.
NOTE: Please make sure shade operates smoothly.
OUTSIDE MOUNT & TENSION DEVICE INSTALLATION
provided screws, install bracket first with large screws (use Chainhold marked
screw hole locations as
reference). Pull the Chainhold down until the chain is fully tensioned
(plunger will be fully raised). Install Chainhold
into bracket with small screws.
NOTE: Please make sure shade operates smoothly.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>