ROLL-A-SHADE RASCP4BCMVER.2 4 Inch Bottom Fascia Coupled Instruction Manual
- June 25, 2024
- ROLL-A-SHADE
Table of Contents
ROLL-A-SHADE RASCP4BCMVER.2 4 Inch Bottom Fascia Coupled
Product Information
Specifications
- Brand: CONTRACT PLUS+
- Model: 4 BOTTOM FASCIA COUPLED
- Contact: Rollashade.com | info@rollashade.com | 951.245.5077
FAQ
Q: What tools are required for installation?
A: #14 Screw Screws, Allen Wrench, 3/8 Hex Head Phillips Head, 1/8 Drill Bit, Drill, Zip Ties.
Q: How do I program the shades to sensors, remotes, or wall switches?
A: The shades may come pre-programmed upon arrival. If not, refer to the programming instructions based on the motor used for your application.
HARDWARE INCLUDED
TOOLS SUPPLIED
TOOLS REQUIRED
INSTALLATION INSTRUCTIONS
-
INSIDE OR OUTSIDE APPLICATION
NOTE: ALL SHADES MAY BE PRE-PROGRAMMED TO SENSORS, REMOTES, AND/OR WALL SWITCHES UPON ARRIVAL -
MOUNTING LOCATION
Place your first bracket in its mounting location and mark the screw holes. Place your brackets in its mounting location and repeat the process. -
SCREW INSTALLATION
Next, pre-drill your screw holes using a 1/8” drill bit. Install the brackets with the provided screws using the 1/4” hex head driver. -
ALIGNMENT
Check to make sure your brackets are level and aligned. -
MOTOR END INSTALLATION
Remove locking ring. Lineup to motor bracket. Push motor into Lock Ring properly. -
LOCK RING & ADDITIONAL LINKED SHADES INSTALLATION
Add locking ring to motor bracket. Check motor is secured correctly. -
SHADE PIN END & FASCIA INSTALLATION
Swivel ball bearing to align with Idler shaft for easy installation. Press Idler shaft all the way to the Bracket. Install bottom fascia -
ADJUSTING COUPLER
NOTE:
No need to disconnect shades to adjust uneven bottom bar. Adjust Srews to level bottom bar. ±1/4’’ Adjustment (total 1/2’’). -
PLUG IN MOTOR
- Run motor power cord to nearest power outlet.
- Install wire tie pads and secure with zip ties to hold wire down.
- The path of the wire should be parallel with mullions and/or drop ceiling tiles ensuring the cable is neatly organized.
- Any modifications to the power cable should be done by a certified electrician to meet your city/state code requirements.
-
SHADE ADJUSTING (IF NECESSARY)
- Roll shade up and down to confirm hembar is level and material rolls up straight on center tube.
- If the hembar is not level, lower shade until you see the metal tube.
- Add layers of masking tape to the metal tube to the end that is too low until hembar is straight.
- If the material tracks to one side, lower shade until you see the metal tube.
- Add layers of masking tape to the metal tube to the end that is opposite the direction of tracking, until shade rolls up straight.
-
ADJUSTING LIMITS (IF NECESSARY)
See programming instructions based on the motor used for your application.
RASCP4BCMVER.2 6 OF 6 | © Copyright Roll-A-Shade® Inc. All Rights Reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>