ROLL-A-SHADE RASOCSMTRVER.1 Lowering and Raising The Shade Instruction Manual
- June 16, 2024
- ROLL-A-SHADE
Table of Contents
ROLL-A-SHADE RASOCSMTRVER.1 Lowering and Raising The Shade
Specifications
- Model: RAS – Shade Operation and Cleaning Signature Motorized
- Location: 12101 Madera Way Riverside, CA 92503
- Phone: 888-245-5077
- Fax: 951-245-5075
- Website: www.rollashade.com
Cleaning Drips and Splashes
If the shade material has been exposed to drips or splashes, it is
important to remove them as quickly as possible. Follow these steps:
- Use a clean absorbent cloth to blot the affected area. Avoid rubbing, as it may spread the liquid further.
- If necessary, repeat the blotting process until the liquid is absorbed.
- If a stain persists, consult a professional cleaner for further assistance.
Operation and Cleaning
Lowering and Raising the Shade
First, select a channel to operate; press one of the four horizontal
buttons near the center of the switch (can select multiple channels at once).
The channel will light green when engaged (press again to disengage). Next,
select the command; shade up (top right), stop (middle right), or shade down
(bottom right). Other commands are 25% open (top left), 50% open (middle left)
or 75% open (bottom left).
Warnings
- Limits are set on the shades causing them to raise or lower to a comfortable length. Do not try to raise or lower the shades past this as it may damage the shade or remote.
- Pulling the bottom of the shade may damage the motor, brackets, or shade, which can cause the shade to become inoperable.
Recommended Cleaning Methods
Cleaning the Shade Material
- Dusting: Regular dusting maintains a like-new appearance of shades.
- Vacuuming: For deeper cleaning, vacuum gently with a brush attachment.
- The best method of cleaning is by regular washing of the fabric using a solution of warm water and mild detergent. Removing window shades may void the manufacturer’s warranty and or damage the motors.
- It is recommended that cleaning occurs at a time of day that allows the shades to dry while in the “down” position (overnight).
Cleaning the Shade Material
- Avoid temperature extremes. Heat accelerates chemical reactions and may evaporate water from the solution. Extremely low temperatures may give poor cleaning effects. Cleaning under adverse conditions may result in streaking or staining. Ideally, cleaning should be done at a moderate temperature and out of direct sunlight.
- All surfaces should be cleaned using a soft cloth or sponge.
- To prevent marring, make sure cleaning sponges, cloth, etc, are grit-free.
- Over-cleaning or excessive rubbing can do more harm than good.
- Strong solvents or strong cleaner concentrations can cause damage to painted surfaces.
- Avoid abrasive cleaners. Do not use household cleaners that contain abrasives on painted surfaces.
- Abrasive materials such as steel wool, abrasive brushes, etc, can harm finishes.
- Never use paint removers, aggressive alkaline, acid, or abrasive cleaners. Always do a test surface.
- Follow the manufacturer’s recommendations for mixing and diluting any recommended cleaners. When using recommended solutions avoid drips and splashes. Remove run-downs as quickly as possible.
FAQ
- Q: Can I operate multiple channels at once?
- A: Yes, you can select multiple channels simultaneously by pressing the corresponding buttons near the center of the switch.
- Q: How do I disengage a channel?
- A: Press the button for the engaged channel again to disengage it. The green light will turn off.
- Q: Can I clean the shade material with harsh chemicals?
- A: No, it is recommended to use a mild detergent and lukewarm water for cleaning. Avoid using harsh chemicals as they may damage the shade material.
www.rollashade.com
© Copyright 2023 Roll-A-Shade Inc., All rights reserved. – Contractor #916075
RASOCSMTRVER.1 Page 1 of 1
CONTACT
- ADDRESS: 12101 Madera Way Riverside, CA 92503
- Phone: 888-245-5077
- Fax: 951-245-5075
- www.rollashade.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>