Thermo SCIENTIFIC Digital Waving Rotator Instructions
- June 29, 2024
- Thermo Scientific
Table of Contents
Thermo SCIENTIFIC Digital Waving Rotator Instructions
Section 3 Overview
3.1 Specifications
3.2 Environmental Conditions
3.3 Safety Instructions
Please read the entire instruction manual before operating the Digital Waving Rotator.
WARNING DO NOT use the Digital Waving Rotator in a hazardous at mosphere
or with hazardous materials for which the unit was not designed. Also, the
user should be aware that the
protection provided by the equipment may be impaired if accessories used are
no provided
or recommended by the manufacturer, or are used in a manner not specified by
the manufacturer.
CAUTION! To avoid electrical shock, completely cut off power to the unit
by disconnecting the power cord from the unit
or unplug from the wall outlet.
Disconnect unit from the power supply prior to maintenance and service. Any
spills should be removed promptly. Bio hazard spills should be cleaned using
approved liquid promptly. Solvent spills are a fire hazard.
Stop the unit immediately, and DO NOT operate until clean up is complete and vapors have dissipated.
DO NOT immerse the unit for cleaning.
DO NOT operate the unit if it shows signs of electrical or mechanical
damage.
Position of Loads
Place the loads in the recommended positions below:
- Place load at the center of the tray
- Place loads symmetrically around the center of the tray
- Make sure to use rubber strips to fasten containers onto the tray
Symmetrical placement
Asymmetrical placement
3.4 Speed and Load
Warning : The actual maximum rotation speed of the instrument may be affected if the cell culture flask is placed at the corner or one side of the tray. If such placement is needed, please make sure to gradually increase the speed.
Section 4 Operation
This chapter covers the control panel and its operation.
4.1 Control Panel
- Run indicator: The light is on when the instrument is running and off when the instrument is in standby.
- Speed display window: The window displays set speed (when the instrument is in standby) or current speed (when the instrument is running).
- Time display window: The window displays cumulative time (in continuous mode) or remaining time (in timer mode).
- Time setting buttons: UP/DOWN arrow buttons are used to increase/ decrease the set time of the instrument.
- Speed setting buttons: UP/DOWN arrow buttons are used to increase/ decrease the set speed of the instrument.
- Run/Stop button: Start or stop the instrument.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>