VIDEOTEC UEBP0 Parapet Bracket Instruction Manual

: June 4, 2024
: VIDEOTEC

Table of Contents

VIDEOTEC UEBP0 Parapet Bracket
About this manual
Typographical conventions
Identification
Preparing the product for use
Installation
Technical data
Documents / Resources

VIDEOTEC UEBP0 Parapet Bracket

About this manual

Read all the documentation supplied carefully before installing and using this unit. Keep the manual in a convenient place for future reference.

Typographical conventions

CAUTION!

Medium level hazard.
This operation is very important for the system to function properly.
Please read the procedure described very carefully and carry it out as instructed.

INFO
Description of system specifications. We recommend reading this part carefully in order to understand the subsequent stages.

Notes on copyright and information on trademarks

The mentioned names of products or companies are trademarks or registered trademarks.

Safety rules

The manufacturer declines all responsibility for any damage caused by an improper use of the appliances mentioned in this manual.
Furthermore, the manufacturer reserves the right to modify its contents without any prior notice.
The documentation contained in this manual has been collected and verified with great care.
The manufacturer, however, cannot take any liability for its use.
The same thing can be said for any person or company involved in the creation and production of this manual.
Before starting any operation, make sure the power supply is disconnected.
Use only original spare parts. Non-original spare parts could cause fire, electrical discharge or other hazards.

Identification

Product description and type designation

Support for ULISSE EVO PTZ, for parapet assembly with cable internal passage.

Preparing the product for use

Unpacking

When the product is delivered, make sure that the package is intact and that there are no signs that it has been dropped or scratched.
If there are obvious signs of damage, contact the supplier immediately.
When returning a faulty product we recommend using the original packaging for shipping.
Keep the packaging in case you need to send the product for repairs.

Safely disposing of packaging material

The packaging material can all be recycled. The installer technician will be responsible for separating the material for disposal, and in any case for compliance with the legislation in force where the the device is to be used.

Contents

Check the contents to make sure they correspond with the list of materials as below:

Support for railing fastening
Bolts and screws
Instruction manual

Installation

Mounting the bracket

Take special care when attaching and fastening down the apparatus. If it is to be attached to a concrete surface you must use dowel pins with a traction torque rating of at least 300dN each. For a metal surface use screws with a diameter of at least 8mm and of an appropriate length. The fastening system must be capable of supporting at least 4 times the weight of the entire equipment (pan & tilt, lens, camera, supports and adapters). The support can be combined with a counter-plate (UEAW) or it can be directly fastened to the chosen surface. Fasten the support using the 3 holes (01). Use the screws with a diameter equal to 8mm. For correct perforation of the fastening surface, use the perforation masking in this manual. (Fig. 4 Perforation masking for UEBP0, page 4).

Fixing the base to the support

Fasten the base (01) on the support (02) using the screws and washers (03).