VIDEOTEC NVXTUB Dust Protection Frontal Shield Instruction Manual
- June 4, 2024
- VIDEOTEC
Table of Contents
VIDEOTEC NVXTUB Dust Protection Frontal Shield
Read all the documentation supplied carefully before installing and using this unit. Keep the manual in a convenient place for future reference.
Typographical conventions
CAUTION!
Medium level hazard.
This operation is very important for the system to function properly. Please
read the procedure described very carefully and carry it out as instructed.
INFO
Description of system specifications. We recommend reading this part carefully
in order to understand the subsequent stages.
Notes on copyright and information on trademarks
The mentioned names of products or companies are trademarks or registered
trademarks.
Safety rules
CAUTION!
Device installation and maintenance must be performed by specialist technical
staff only.
- The manufacturer declines all responsibility for any damage caused by improper use of the appliances mentioned in this manual. Furthermore, the manufacturer reserves the right to modify its contents without any prior notice. The documentation contained in this manual has been collected and verified with great care. The manufacturer, however, cannot take any liability for its use. The same thing can be said for any person or company involved in the creation and production of this manual.
- Use only original spare parts. Non-original spare parts could cause fire, electrical discharge or other hazards.
Identification
Product description and type designation
Front sunshield that prevents dust from depositing on the window of the
housing.
Preparing the product for use
Any change that is not expressly approved by the manufacturer will invalidate the guarantee.
Safety precautions before use
Before starting any operation, make sure the power supply is disconnected.
Unpacking
When the product is delivered, make sure that the package is intact and that
there are no signs that it has been dropped or scratched. If there are obvious
signs of damage, contact the supplier immediately. When returning a faulty
product we recommend using the original packaging for shipping. Keep the
packaging in case you need to send the product for repairs.
Safely disposing of packaging material
The packaging material can all be recycled. The installer technician will be
responsible for separating the material for disposal, and in any case for
compliance with the legislation in force where the device is to be used.
Contents
Check the contents to make sure they correspond with the list of materials as
below:
Installation
If previously installed, remove the sun shield and washer nozzle from the camera. Align the dust prevention sunshield with the screw holes on the front of the housing as illustrated in the figure.
Fasten the dust prevention sun shield (01) to the front of the housing using the 3 washers and screws supplied (02).
Pay attention to the fixing. Tightening torque: 4.5Nm.
Technical data
Mechanical
Made of electro-polished stainless steel AISI 316L Dimensions (ØxL):
175×121.5mm (6.9×4.8in). Unit weight: 0.817kg (1.8lb).
Technical drawings
The indicated measurements are expressed in millimeters.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>