Schlage BE367/BE367F Camelot Programmable keyless Deadbolt Installation Manual

Installation Instructions

BE367/BE367F

Tools

A. Key
B. Cylinder Cap
C. iButton Assembly
D. Deadbolt
E. Mounting Plate
F. 9v Battery
G. Mounting Screws (2)
H. Thumbturn Assembly
J. Screws (2)
K. Drive-in Faceplate
L. Square-corner Faceplate
M. Rounded-corner Faceplate
N. Deadbolt/Strike Screws (4)
P. Strike
Q. Reinforcement Screws (3)
R. Dust Box
S. UL Cup (BE367F ONLY)
T. UL Screw (BE367F ONLY)

Install Lock

1  Template Is Included In Box

IMPORTANT: Template shown is not full size

2 Check Door Holes

Note: If holes do not match template, purchase a GuideRight® jig or visit www.schlage.com for door drilling instructions.

3 FOR BE367F ONLY: Measure and Drill Hole

4 FOR BE367F ONLY: Install UL Cup

5 If Needed, Adjust Deadbolt

6 Choose Deadbolt Faceplate

Match faceplate to your door.

7 Install Deadbolt

8 Install Keypad Assembly

IMPORTANT: Cable passes over top of deadbolt.

9 Install Inside Mounting Plate

IMPORTANT: Pull excess wire through mounting plate.

10 Check Cam and Install Screws

NOTE: Ensure lock is straight before tightening.

11 Install Battery and Connect Cables

12 Route and Tuck Cables

13 Install Thumbturn

14 Install Strike and Dust Box

Check Operation

A If you have a yellow construction iButton Credential, then test lock operation

IMPORTANT: If the BE367 is unprogrammed, then all yellow construction iButtons will operate lock. Yellow Construction iButtons are disabled automatically when the BE367 is programmed.

B  For Programming, See the SMS/SMS Express Site Set-Up Guide

Questions? 888-805-9837

© Allegion 2014
Printed in U.S.A.
P515-488 Rev. 11/14-online

Schlage BE367/BE367F Camelot Programmable keyless Deadbolt Installation Manual – Optimized PDF
Schlage BE367/BE367F Camelot Programmable keyless Deadbolt Installation Manual – Original PDF

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>