Schlage FE575/FE595 Door Preparation Instructions Manual
- June 8, 2024
- Schlage
Table of Contents
FE575/FE595 Door Preparation Instructions
For Door With Existing Holes
Tools Needed
Tape MeasureDrill Bits Needed
Drill Bits Needed:¹⁄₈”, ⁷⁄₈”, 1”
Hole Saw
2¹⁄₈” Hole Saw
Pencil
Pencil
Chisel
Chisel
- Measure Door Width
If the door is thinner than 1³⁄₈” or thicker than 1³⁄₄”, then the lock will not fit properly on the door.
2. Measure for Backset
If existing backset is not 2³⁄₈” or 2³⁄₄”, then the lock will not fit properly on the door.
3. Measure Hole Sizes
If hole sizes are larger than those shown, then the lock will not fit properly on the door.
If hole sizes are smaller than those shown, see steps 4 and 5.
4. If Needed, Enlarge Hole in Door
If hole in door is smaller than 2¹⁄₈”, then use 2¹⁄₈” hole saw to enlarge hole.
5. If Needed, Enlarge Hole in Door Edge
If hole in door edge is smaller than ⁷⁄₈”, then use ⁷⁄₈” or 1” drill bit to enlarge hole.
6. Check Strike (Door Jamb) Preparation
a. Place new strike against door jamb.
b. If strike does not fit properly , use pencil to trace around strike and mark hole positions.
c. If needed, use chisel and drill to correct door jamb preparation
© Allegion 2014
Printed in U.S.A.
FE575/595 DP existing holes
Rev. 11/14-online
Schlage FE575/FE595 Door Preparation Instructions Manual – Optimized
PDF
Schlage FE575/FE595 Door Preparation Instructions Manual – Original
PDF
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>