Schlage Control Smart Deadbolt FE410F Installation Manual
- June 8, 2024
- Schlage
Table of Contents
Schlage Control™ Smart Deadbolt
with Engage Technology
Model FE410F
Door Preparation Instructions for Door with No Holes
Tools Needed
Pencil
Pencil
Drill Bits Needed
Drill and Drill Bits
Bit Sizes: ¹⁄₈”, 1”
Hole Saw
Hole Saws
1″ 2¹⁄₈”
Chisel
ChiselHammer
Hammer
1 Measure door thickness.
If the door is thinner than 1³⁄₈,” or thicker than 1³⁄₄”, then the lock will not fit properly on the door.
A thick door kit is available from Product Support at 800-847-1864.
2 Mark lock centerlines.
2a Mark bottom centerline on door face, door edge and door jamb.
Door Edge, Door Jamb, Door Face, 38” from
finished floor, Tape
2b Mark top centerline on door face, door edge and door jamb.
Door Edge, Door Jamb, Door Face, 4” or 5Z\x” from bottom
centerline
Locks are ordered as either 4” or 5 ½”.
3 Prepare cross bores.
3a Measure backset and mark center of holes.
3b Drill holes with hole saw.
Hole Saw
4 Prepare door edge holes.
4a Measure and mark ½ door thickness.
Door Thickness
4b Drill holes in door edge.
Drill Bit or Hole Saw
5 Mortise for latch and bolt.
5a Insert latch into door edge hole. Trace latch faceplate and mark holes.
5b Remove latch and bolt. Drill four ¹⁄₈” pilot holes.
Drill
Bit
5c Use chisel and hammer to create mortise for latch and bolt.
6 Measure, mark and drill holes in door jamb for strikes.
6a Mark center for strike holes exactly opposite latch and bolt holes.
6b For the bolt strike, measure, mark and drill two (2) 1” holes, 1¼” deep, as
shown. Chisel out excess material on the sides.
Drill Bit or Hole Saw
6c For the latch strike, measure, mark and drill two (2) 1” holes, ½” deep, as shown. Chisel out excess material on the sides.
Drill Bit or Hole Saw
7 Mortise for latch and bolt strike.
7a Trace latch strike and bolt reinforcement plate. Mark holes.
7b Drill six (6) ¹⁄₈” pilot holes.
Drill Bit
7c Use chisel and hammer to create mortise for strikes and reinforcement plate.
Mortise for latch strike extends all the way to the edge of the jab to allow for the latch lip.
Product Support
© Allegion 2016 FE410F door prep no holes-b Rev. 05/16-a
Schlage Control Smart Deadbolt FE410F Installation Manual – Optimized
PDF
Schlage Control Smart Deadbolt FE410F Installation Manual – Original
PDF
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>