Schlage FE575/FE595 Keypad Lever Preparation Instructions Manual
- June 8, 2024
- Schlage
Table of Contents
FE575/FE595 Door Preparation Instructions For Door With No Holes
Tools Needed
Drill Bits Needed: ¹⁄₈”, ⁷⁄₈”, 1”
2¹⁄₈” Hole Saw
Pencil
Chisel
1. Measure Door Width
If the door is thinner than 1³⁄₈” or thicker than 1³⁄₄”, then the lock will not fit properly on the door.
Tape Measure
2 Mark Lock Centerline on Door Face and Door Edge
Tap Measure, Door Edge, Door Face, 38” from finished floor
3 Mark and Drill Hole in Door Face with 2¹⁄₈” Hole Saw
4 Mark and Drill Hole in Door Edge
OR For
5 If Necessary, Mortise for Latch
a. Insert latch into door edge hole.
b. Use pencil to trace latch and mark holes.
c. Remove latch and drill two ¹⁄₈” pilot holes.
d. Use chisel to create latch mortise.
6 Measure Door Jamb for Strike
Door Jamb, 38” from Floor
7 Mark and Drills Holes for Strike
a. Measure 38” from finished floor and mark on door jamb.
b. Mark center for strike hole exactly opposite latch hole.
c. Drill 1” hole, ¹⁄₂” deep.
d. Line up strike with hole in door jamb.
e. Use pencil to trace strike and mark holes.
f. Drill two ¹⁄₈” pilot holes and use chisel to create strike mortise.
Door Jamb, Latch Hole
© Allegion 2014
Printed in U.S.A.
FE575/595 DP no holes
Rev. 11/14-online
Schlage FE575/FE595 Keypad Lever Preparation Instructions Manual – Optimized
PDF
Schlage FE575/FE595 Keypad Lever Preparation Instructions Manual – Original
PDF
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>