EB43 True Wireless Earbuds Quick Start Guide

EB43 True Wireless Earbuds Quick Start Guide

GETTING STARTED

1. Micro USB charging port
2. Charging Case LED indicators
3. Charging Case Power Button
4. Left earbud LED indicator
5. Left control button
6. Right earbud LED indicator
7. Right control button

LeftEarbud / RightEarbud
Pause/Play/Answer Call/End Call, Next Track

CHARGING YOUR CASE

• Charge on the go charging case, with the included micro USB cable for 2-3 hours. (LED (2A) will blink red) Do not charge longer than suggested time. Do not charge overnight.
• When LED (2A) is illuminated solid red battery case is fully charged.

CHARGING YOUR EARBUDS

• Place Right and Left Earbuds in battery case charging cradle and press the power button on the battery case (3)
• Charging case LED indicator (2B) will illuminate Blue and the earbud LED indicators (4, 6) will illuminate Red, indicating that the earbuds are charging properly. When Earbuds LEDs (4, 6) turn solid blue, earbud batteries are fully charged.
• After earbuds are fully charged, press the charging case power button (3) to turn the charging case OFF.

MONO MODE (SINGLE EARBUD USE)

• Remove earbud from charging cradle andpower on by pre ssing the control button (7) or(5) for 3 seconds depending on which earbud your using.
• Once earbud is powered on, proceed to PAIRING

STEREO MODE (DUAL EARBUD USE)

• Remove both earbuds from charging cradle and place them in your ears.
• Make sure Bluetooth® Search Mode is turned off on your mobile device.
• Hold the right earbud button (7) for 3 seconds and then press left earbud button (5) for 3 seconds untilthey are powered on. (Earbud LEDs will flash Red and Blue to indicate that they are in Link mode.)
• Earbuds will automatically link together after a few seconds,and earbuds will have a tone (LEDs will flash blue)
• Once Earbuds are linked together you may proceed to pairing with your mobile device.

PAIRING

*Note: Once earbuds have been initially paired successfully with your mobile device they will automatically pair the next time they are powered on.

OPERATING BLUETOOTH EARBUDS

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note:This equipment has been tested and found to comply with the limits for a class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequence energy and,if not
installed and used in accordance with the instructions,may cause harmful interference to radio communications.However,there is no guarantee that interference will not accor in a particular installation.if this equipmemt does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an autlet on a circuit different from that to which the receiver is connectec.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

EB43 True Wireless Earbuds Quick Start Guide – Download [optimized]
EB43 True Wireless Earbuds Quick Start Guide – Download

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>