luxorparts Digital outdoor timer User Manual
- June 7, 2024
- luxorparts
Table of Contents
luxorparts Digital outdoor timer User Manual
www.luxorparts.com
Box 50435 Malmo
Sweden
2020-03-23
Luxorparts®
Specifications
Installation:
Start by plugging the timer into a free wall socket to charge the built-in battery. Let the battery charge for 10 minutes so the backup function works properly.
Never put two timers in the same wall socket
Reset
You can easily clear all stored settings from the timer by pressing the little button just above the week button. This will reset all the settings.
Time settings
Press and hold the CLOCK button and press the WEEK button until the correct weekday is set. Continue by pressing the HOUR and MINUTE button to set the correct time as well. Release the CLOCK button when these settings are done.
12/24 hours
Press CLOCK and TIMER buttons at the same time to change time format.
Daylight saving time
Press the CLOCK and ON/OFF/AUTO buttons at the same time. The clock will skip one hour ahead and display an ” S”. Press the same buttons again to change back.
Priorities
The timer can have many active settings at the same time. Some settings are prioritized in order to not interfere.
Manual settings
Random program start
Programs (Auto mode enabled)
Manual settings
Press MANUAL to switch between the On, Off and Auto modes. Programs are only active if the Auto Mode has been chosen.
Random program start
Activate the random function by pressing RNO. Your programs will act as usual except for between 18:00 to 06:00. During this time, it will alternate on/off with an interval of 10 to 31 min. Press RNO again to turn off the function.
Program
Press TIMER once, ON should show on the display. Press WEEK and choose the day of the week or combination of days you want the program to be active. Continue by setting the time with the HOUR and MINUTE buttons. When these steps are done press TIMER to proceed to set the settings for when the program should not be active. Repeat the above mentioned steps. You’ve now set the settings for the first program, there are 9 additional programs you can set if wanted.
Note : To revoke any program, press the RST/RCL button in the program setting mode. The display will replace the program with dashes”–:–“. Make sure the various programs don’t overlap, the timer will prioritize time, not program order. OFF settings are also prioritized over ON. To start the programs, make sure that the Auto mode is enabled as described under Manual Settings above.
Safety information
The mains plug is used as the disconnect device, therefore the mains plug
shall remain readily operable.
Children should be supervised to ensure that they do not play with the
appliance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>