Luxorparts 64148 150 LED RGB Strip Instruction Manual
- June 6, 2024
- luxorparts
Table of Contents
Luxorparts 64148 150 LED RGB Strip Instruction Manual
Overview
- On
- Off
- Decrease brightness
- Increase brightness
- Colours
- Colour hues
- Flash
- Strobe
- Fade
- Smooth
- Battery tray
Specifications
Voltage: 12 V, 2 A
Power consumption: 24 W
LED strip length: 5 m
Power cable length: 1.5 m
Extension cable length: 4x 10 cm
IP code: LED strip IP65, adapter IP20
Width: 10 mm
Before use
Clean the area where the strips will be attached so the 3M tape can stick to the surface as good as possible.
Application
The strip can be cut every 10 cm, it’s indicated with a pair of small scissors where to cut (IP code can’t be guaranteed if cut). Peel off around 5 mm of the plastic casing so the connector points are open and clean. The metal teeth on the extension cable need to have contact with the connector points on the strip. Make sure to place the strips so their markings are the same at all connecting ends (match the markers), as seen below. Close the clamp by pressing the two plastic pieces together.
When you’ve matched the ends accordingly peel off the 3M tape and carefully attach the strips. When in place, attach the extension cables and connect the RGB control box and wall plug. There is also a small IR diode on a separate cable on the control box that has to be visible for the remote control to be able to work.
Power on/off
Connect the power adapter to a wall plug. Turn on the light strip with the [On] button (1). Turn off the light strip with the [Off] button (2).
Set the brightness
Press the [Increase brightness] button (4) or the (Decrease brightness] button
(3) to adjust the brightness.
When a “light scene” is active, the brightness can not be controlled. To
adjust the bright-ness on “light scenes”, change the brightness on a fixed
colour (S, 6) and then choose the “light scene” again.
Choose colour
The light strip can shine in 16 different colours, switch between them by pressing the [Colour buttons] (5) and [Colour hue buttons] (6) on the remote control.
Light scenes
[Flash] (7) In The strip jumps between all colours.
[Strobe] (8). The strip fades on and off with a white light. [Fade] (9). The
strip fades between all colours.
[Smooth] (10). The strip fades between red, green and blue.
Replace battery
The battery tray (11) is placed at the bottom of the remote control. Remove it by pushing the lock on the side of the tray at the same time as you pull it out. The battery should be placed with the positive polarity (+) side facing upwards.
Safety information
Only intended for household use. The LED strip can be placed outdoors. The power adapter must be placed indoors. Only use the provided power adapter. Do not connect power to the strip while it’s in the packaging or wound onto a reel. Do not cover the LED strip or place it in a recess. Do not open the strip OP code can’t be guaranteed if opened). The LED lights can not be replaced. Depleted batteries should be removed and replaced by a similar kind. Dispose batteries according to local regulations.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>