Luxorparts 50003 Energy Meter User Manual
- June 4, 2024
- luxorparts
Table of Contents
Luxorparts 50003 Energy Meter
Overview
- Reset
- Up
- Set
- Function
- Battery compartment
Installation
Remove the plastic insulator separating the batteries from the energy meter.
You may need to open the battery compartment to reach it. Close the battery
compartment and press Reset (11 using a pin. The batteries are used to keep
the energy meter settings, if the energy meter is moved from a wall socket to
another. If the batteries run out and the energy meter is disconnected from a
wall socket, all settings are lost.
Insert the energy meter into a wall socket and connect an appliance to the
energy meters socket. The energy meter measures the electricity passing
through it and displays voltage (VI, current (Al or consumption (WI
alternatingly on the display since the last time the energy meter was reset.
Don’t use two energy meters in the same wall socket and make sure the current
(W) does not exceed the total capacity (3,600 W).
If none of the buttons are pressed for 10 seconds, the energy meter display
enters sleep mode to save battery Press any button to wake it up.
Time settings
- Press Set (3) when time is displayed to start setting the time.
- Weekdays flash. Press Up (2) to select weekday.
- Press Set (3) again to edit hours, select hour using Up (2).
- Press Set (3) again to edit minutes, select minutes using Up (2).
- Finish time settings by pressing Set (3).
Time format
Press Up (2) when time is displayed to choose 12 or 24 hour time format.
Display mode
- Press Function (4) to cycle between the different display modes: Voltage (VOLTac) -> Current (AMP)-> Real-time consumption (WATT)-> Total consumption (kWh)-> Total price-> Price 1 (if entered)-> Price 2 (if entered)
- Press and hold the Function button (4) for 5 seconds when Total price/price 1 /price 2 are displayed to reset the meter.
Price settings (price/kWh)
- Press and hold the Function button (4) for 1 second when voltage, current or consumption is displayed to open price 1 settings.
- Press the Set button (3) multiple times followed by Up (2) to switch between decimals and enter the correct price as well as weekday and time when that price setting should be active in the same manner as the time settings were explained earlier.
- Press the Function button (4) again to open price 2 settings after price 1 is set.
- Press the Function button (4) to go back to price 1 settings and press and hold the Function button (4) for 3 seconds when price 1 is displayed to go back to the regular alternating display mode.
- Press and hold the Function button (4) for 3 seconds when price 2 is displayed to clear weekday and time.
- The display shows price 1 setting and “-:–” is shown on the display
Note! Price 1 must be set before price 2 can be entered.
Reset all settings
Push the Reset button (1) using a pin to reset all settings on the energy meter.
Specifications
Safety information
The mains plug is used as the disconnect device, therefore the mains plug shall remain readily operable. This appliance is only intended for household use and may only be used indoors. Children should be supervised to ensure that they do not play with the appliance
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>