Luxorparts Digital Timer User Manual

Luxorparts Digital Timer

Overview

1. M-Clear (reset)
2. CLK (clock)
3. Left
4. Right
5. Set
6. RND (random)
7. CDT (countdown)
8. Manual (choose mode)

Specifications

Power supply            230 V, 50 Hz
Capacity                   16A, 3600W
Battery                      NiMH 1,2 V > 100 h
Temperature            -10 °C to 40 °C
Programs                 20
Accuracy                  +/- 1 minute/month

Installation:

Start by plugging the timer into a free wall socket to charge the built-in battery. Let the battery charge for about 14 hours. Press M-Clear (1) to reset the timer. Never put two timers in the same wall socket.

Time settings

1. Press Set 15) for five seconds.
2. Enter the weekday by using Left (3) and Right (4).
3. Press Set 15) again, followed by Left 13) and Right (4) to enter the hour.
4. Press Set 15) again followed by Left (3) and Right (4) to enter the minute.
5. Finish by pressing Set (5).

12/24 hours
Press CLK (2) for three seconds to change time format.

Daylight saving time
Press CLK (2) and Left 13) at the same time. T he clock will skip one hour ahead and display an “S”. Press the same buttons again to change back.

Priorities

The timer can have many active settings at the same time. Some settings are prioritized in order to not interfere.
Manual settings
Random Program Start
Countdown Timer
Programs (Auto mode enabled)

Manual Settings

Press Manual (8) to switch between the On/Off and Auto modes. Programs are only active if the Auto mode has been chosen.

Random program start

Activate the random function by pressing RND (6). Your program will act as usual with the exception of  a randomly timed delay of 2-30 minutes. The total program time is still the same. press RND (6) again to turn off the function. The random function can’t be active in normal programs.

Countdown timer

• Press Left (3) to configure the countdown timer.
• Press set (5) to switch between, hours, minutes, and seconds.
• Press left (3) and right (4) to enter values.
• Press CDT (7) when done to start the countdown.
• To reset the countdown settings, press Manual (8). The countdown can’t be active during normal programs.

Program

The Example below configures the program “Timer  on at 17:15 and off at 22:30 each day”. Up to 20 programs can be active simultaneously. See to it that you programs does not overlap, since the on/off won’t work as intended. Off is prioritized before on.

Press the right (4) until the screen enters the program mode and displays a flashing “On 1” (on time for program 1). Press left (3) or right (4) to choose another program spot (up to 20). Press set (5). The weekdays Flash. Press left 3 or right 4 until the weekdays are marked.
Press  set (5) again, followed by left (3) and right (4) to enter hours. Choose “17”.
Press  set (5) again, followed by left (3) and right (4) to enter minutes. Choose “15”.
Press set (5) again, followed by Right (4) to configure OFF (off time for program 1).
Repeat the procedure, with the setting of the “off 1” time, but choose “22:30” instead. Finish by pressing set 5.
Press manual (8) when viewing the program settings to switch between and view or change your saved programs.
To start the programs, make sure that the Auto mode is enabled as described under Manual Setting above. Random and/or countdown features may not be activated.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>