Tws LY09 True Wireless Earbuds User Manual
- June 8, 2024
- TWS
Table of Contents
Tws LY09 True Wireless Earbuds
TWS Accessories
WARNINGS
- The headset should be stored in a dry and ventilated environment, avoid contact with oil, water vapor, steam, moisture and dust, so as not to affect the performance and life of the product. It is strictly forbidden to place the headphones in a high temperature environment exceeding 50°C, otherwise the battery may crack.
- Keep away from WIFL, router or other high frequency transmitting equipment to prevent interruption signal receiving.
- Please use this headphone within its working distance range(10 meters-15 meters) and make sure there is no obstacle between earbuds and mobile device to have better connection
- Charging voltage current(5V 0.6-0.8A), Do not use other high voltage or high current chargers for charging
- To ensure that you use the headset normally, please ensure that the charging case and headset have sufficient power.
SPECIFICATIONS
Headphone use steps and special instructions
-
Put the headset into the charging box to enter the charging mode, The headset tums off automatically.
-
Before first pairing with your device, please make sure the earbuds is fully charged.
Then, turn on the Bluetooth of your mobile devices. For devices with different operation system, please follow steps below to pair: -
1os devices: You will see AirPods show on your iPhone/ iPad and please press Connect to continue.
-
You will see LYO9 on screen with battery status of both Earbuds and Charging Case.
-
At last, please press’ Continue’ to finish the first pairing. You can check the status of this headphone on Battery Widget
Android & other devices: -
Go to Blue tooth Settings of your phone and find devices name ‘LY09
-
select this device to pair
-
If the headset is not connected for 5 minutes, the Bluetooth Headphone will automatically shut down
-
The Green Lights on charging bars inside the charging case flashes when it’s charging.
You will see all Green Light on charging bars stay on when it’s charged -
Tum it off and then tum it on again, the headset will automatically connect to the phone
Third Generation Side Touch Menu
- L/Presence: pause/play
- L press 2 times: previous song
- R press 2 times: next song
- L press 3 times: Volume
- R press 3 times: Volume+
- Long press L/R for 3s: Call Voice Assistant
Incoming Call
- L/R press 1 time: answer/hang up Long press
- L/R for 25: reject the call
Packing List
- Bluetooth Earbuds (2pcs)
- Headset Charging Case
- USB A to USB C Charging Cable
- User Manual
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
if this equipment does cause harmful interference to radio or television
reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Thedevice has been evaluated to meet generalRF exposure requirement.
The device can be used in portable exposure condition without restriction