mercury 2.4GHz Wireless Door Phone User Manual

mercury 2.4GHz Wireless Door Phone User Manual

This wireless door phone system allows you to talk to your visitors before opening the door. No wires are required between the external and internal units, making this system very easy to install, and a range of up to 150m makes this useful for security and helpful for the elderly or less mobile.

Features:

• Easy to install; no wiring required
• Battery operated IP44 rated external unit with low power consumption
• Battery back-up feature on internal unit
• Wireless range up to 150m (clear sight)
• Adjustable ringer volume

In the box:

• IP44 rated external call unit
• Internal handset & cradle
• Internal handset PSU
• Fixing kit
• User guide

Installation: External Call Unit

1. Fasten the rain shade on the wall 1.4~1.7m above the ground.

2. Remove the screw from the bottom of the external unit and remove the bottom plate.
   

3. Remove the silver cover and install 4 x AA batteries (not supplied) paying attention to the polarity indicators within the battery compartment.

4. Remove the name card cover and complete the card as required ie. name, room number, etc.
   

5. Attach the unit to the rain shade.

6.  Replace the cover.
   

7. Replace the bottom plate.

Internal Handset

Ensure that there is a power outlet within reach of the handset and its power supply.

1. Remove the cradle from the rear of the handset and attach to the wall.

2. Open the battery cover, install 4 x AA batteries (not supplied) and replace the cover.
   

3. Plug the power supply into a power outlet and switch it on. The handset will beep. The system is now ready for use.

Operation:

In standby mode, the handset LED will blink every 3 seconds.
When the call button is pressed on the external unit, the handset will chime twice and the LED will change from blinking to steady.
The external unit will also sound intermittently for approximately one minute or until the handset is picked up to receive the call. Lift the handset to speak to the caller.
At the end of the call replace the handset ensuring that it is secure in its cradle. Both units will beep. If left unanswered, both units will beep after one minute and the system will return to standby mode. The handset LED will blink rapidly for 10 minutes to indicate that the call button has been pressed after which time it will return to one blink every 3 seconds.

With good quality batteries installed in the handset, the system will operate for several hours during a mains failure. Please note that the handset is not capable of recharging batteries and only dry cells should be used.

System alerts:

Warning:

• For reasons of electrical safety, this device must never be immersed in water, exposed to damp conditions or excessive force.
• Do not use this device if you find that it is damaged in any way.
• Do not attempt to repair this device or take apart under any circumstances, as this will invalidate your warranty.
  

This product is classed as Electrical or Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life. The goods must be disposed of according to your local council guidelines.

Errors and omissions excepted.

Copyright© 2020 AVSL Group Ltd, Unit 2 Bridgewater Park, AVSL (Europe) Ltd, Unit 3D North Point House,
Taylor Road, Trafford Park, Manchester. M41 7JQ.

Read More About This Manual & Download PDF:

References

• AVSL
• AVSL

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>