ORTECH SLIM6-3CCT LED Slim Lights Instruction Manual
- June 3, 2024
- Ortech
Table of Contents
ORTECH SLIM6-3CCT LED Slim Lights
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
- LED Slim Lights are suitable for indoor use only. DO NOT use outdoors.
- Please keep the LED Slim Lights away from any corrosive substance, and please use dry cloth when you clean it.
- LED Slim Lights can only be installed by a qualified electrician.
- Before installation or maintenance, please disconnect the power to prevent electric shock.
CAUTION
PLEASE READ INSTRUCTIONS BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCE. Electrical products can cause death or injury, or damage to property. If in any doubt about the installation or use of this product, consult a competent electrician.
INSTALLATION GUIDE
Tools Required
- Saw
- Measuring Tape
- Electrical Wiring (use type and gauge suitable for application to connect the fixtures)
PRE-INSTALLATION
- Turn power OFF from the electrical panel before starting installation.
- Locate a suitable position to plate the fixture and open in accordance to the cut-hole dimensions (refer to Hole Cut Table for appropriate size).
- Run electrical wire from the switch (power supply) through the mounting hole-use NMD90 Romex or BX cable.
DRIVER WIRING
- Open the driver box swing cover and remove the appropriate knockout (s).
- Insert the electrical supply cable through the knockout and secure with a cable connector (sold separately).
- Using wire nuts, connect green ground wire of the cable to the green wire on the box. Connect the white wire of the cable to the white wire of box. Connect black wire of cable to black wire of box.
- Place all wiring and connections back in to the box and close the cover. Insert the driver box through the mounting hole. New construction applications: driver box shall be finmly secured to studs, joists, or similar fixed structural units. Remodel applications: Do not require the driver box to be firmly secured after the mounting plates, studs, joists, or structural units have been concealed.
ORTECH reserves the right to modify at any time, without notice, any or all of
our product’s features, designs, components and specifications to meet market
changes.
FIXTURE INSTALLATION
- Connect the fixture to the driver box by inserting and twisting the male/female connectors.
- Push spring-loaded clips on the fixture upwards and insert the fixture base into the mounting hole. Release the clips and the fixture will be pulled flush to the ceiling.
- Once assembly is complete, turn on the power to confirm the fixture is working properly.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>