ONFORU BDTYB03 LED Solar Light User Manual

: June 5, 2024
: ONFORU

**ONFORU BDTYB03 LED Solar Light User Manual

**

SAFETY INFORMATION

Please read the following content carefully before using the device!
This product is solar powered. The solar panel should be installed on the position with direct sunlight for the longest time;
This product has not been used for a long time. When used again, it needs to be charged by sunlight before it can be used;
Regularly wipe the surface of the solar panel with a dry towel. Dust and stains on the surface will affect the charging of the solar panel;
This product has a built-in battery, do not directly burn the damaged product with fire;
This product is operated by battery, keep away from high temperature objects when using, especially the environment over than 85 degrees centigrade; Please do not use this product in the environment where with corrosive gas or humid;

PARAMETER

| A – 270x95x95 mm 10.64×3.72×3.72 in
---|---
| 4.2V
| Daylight White 6500K
| IP65
| -25°C – 40°C

COMPONENTS AND STRUCTURE

Cover
LED Light Source
Motion Sensor
Solar Panel
Base
3 Lightning Modes

3 Lightning Modes

Motion Sensing Mode One: When a person passes, the light turns on at 100% brightness. 20 seconds after the person left, the light is always bright at 5% brightness.
Motion Sensing Mode Two: When a person passes, the light turns on at 100% brightness. 20 seconds after the person left, the light turns off; Red indicator flash slowly.
No motion mode: The light be always bright at 20% brightness.

NOTE: The maximum sensing range is 19.69 to 26.25 foot with 120° wide angle.

NOTE

01 Safety Class III=Only operate lamps with this symbol with Safety Extra Low Voltage (SELV), Only connect to SELV circuits.
When cleaning and maintaining the product, please make sure the power supply is disconnected and the battery is removed.

INSTALLATION STEPS

Remove the base from the product and mount it on the wall with screws and expansion pipe.
Install the wall light on the base, and then adjust the angle according to your need.
The best place of solar panel is oriented to the south.
Solar panel must be installed at the place with sufficient sunlight and long exposure time.
Please ensure that no object keeps out the sunlight for solar panel.

DISPOSAL

Operation

Never use any chemicals or corrosive substances for cleaning.

Disposal

Electrical and electronic equipment, accessories and packaging must be recycled in an environmentally compatible manner.

FAQ

Where are solar panels installed?

Install the solar panel in the place where expose to most sufficient sunlight. The best place is oriented to the south.

Why can’t solar panels be charged?

The solar panel can charge the internal battery by direct or indirect light. Please adjust the solar panel installation position for best charging effect.

Why does the light flash?

Because the battery power is low. Turn off the light, then make the solar panel be charged about 1-2 days until it is fully charged. Turn on the light again and it will work normally.

Why doesn’t the lights work?

Please make sure that the battery has enough power.
You can turn off the light, then make the solar panel be charged about 1-2 days.
Turn the light on again after the battery is fully charged, it will work normally.

Manufacturer

Shen Zhen Shi Meng Zhi Tuo Ke Ji You Xian Gong Si
Address: qian wan yi lu 1 hao A dong 201 shi qian hai shen gang he zuo qu Shen Zhen, Guang
Dong, 518000, CN
support@onforuled.com www.onforuleds.com