beper P101BOL100 Electric Kettle Instruction Manual
- June 3, 2024
- beper
Table of Contents
P101BOL100 Electric Kettle
Instruction Manual
Precautlons
Read the following instructions carefully, since they give you useful safety information about installation, use and maintenance and help you avoid mishaps and possible accidents.
- Remove the packing and make sure that the appliance is intact, with special attention to the supply cable.
- The elements of the packing (plastic bags, polystyrene, etc) do not have to be accessible to the children, in order to preserve them from danger sources. It is recommended not to throw these packing material in the domestic waste, but to deliver them to the appropriate station of collection or destruction refusals, asking eventually information to the manager of the Sanitation Department of your own municipality.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
- Before connecting the appliance make sure that the mains voltage corresponds to the data specified on the label.
- The appliance can be damaged if the voltage is not correct.
- If the plug does not suit the socket, let it be replaced with another suitable plug by qualified personnel only, which shall also ensure that the section of the socket cables is suitable for your appliance power absorption.
- Generally, the use adaptors multiple plugs and/or extensions is not recommended; should they be necessary, please use only simple or multiple adaptors and extensions in compliance with the safety rules in force, making sure that the capacity absorption limit marked on the simple adaptors and the extensions and the maximum power limit marked on the multiple adaptor are not exceeded.
- Do not use the appliance if the cable or the plug shows any damages. Do not use the appliance after a possible irregular working. In this case, switch it off and do not break it open. Refer to an authorized Beper after-sale service for repair and require original spare parts only. Failing to follow these instructions may impair the safety of your appliance.
- This appliance is to be destined to its special purpose only. Any other use is to be considered as improper and thus dangerous. The manufacturer cannot be responsible for any damages deriving from impro- per, wrong or incautious use.
- This appliance is for household use only.
- To protect against electric shock, do not immerse cord, plug or any parts of the appliance into water or other fluids.
- Do not use the appliance near explosives, highly flammable mate- rials, gases or burning flames.
- Do not allow children, disabled people or every people without experience or technical ability to use the appliance if they are not properly watched over. Close supervision is necessary when any appliance used by or near children.
General description
- Lid with opening button
- On/Off switch
- Power indicator light
- Handle
- Water level indicator
- Base
- Kettle body
- Pouring spout
Use
Place the kettle on a flat, stable surface.
Remove the kettle body from the base and fill it with water, respecting MIN
and MAX levels as indicated on the water level indicator. Water can be filled
by opening the lid or through the pouring spout. Close the lid and place the
kettle body on the base. Plug the appliance to the electrical socket.
Press on/off switch upwards and the kettle starts to operate. The power
indicator lights up. When the switch and the light turn off, water is ready
for use. Press on/off switch downwards to interrupt the heating anytime.
Lift the kettle body only by the handle.
The kettle becomes very hot and must not be touched with hands directly.
The kettle must be used only with its base.
Disconnect the cord supply form the electric socket.
In case that by mistake, the kettle is turned on without water, the kettle
will turn off automatically thanks to its safety device.
Usually when the kettle is new it could happen that the water has an altered
taste, it is recommended to throw away the water of the first uses. If the
problem persists, fill the kettle to the maximum, add two teaspoons of baking
soda, boil and throw away the water, then rinse the kettle
Cleaning
Disconnect the plug from the socket.
Let the kettle cool down and clean it with a damp sponge.
Never use abrasive sponges for cleaning.
Descale regularly, preferably once a month or more frequently if the water is
very hard.
To descale the kettle, you can use 8 degrees white vinegar, available on the
market or citric acid as follows:
Fill the kettle with half a litre of vinegar, let it rest for an hour without
heating, empty the kettle and rinse it 5 or 6 times. Repeat if necessary.
Otherwise boil half a litre of water, add 25 g of citric acid and leave for 15
minutes, empty the kettle and rinse it 5 or 6 times. Repeat if necessary.
Do not use other descaling methods other than those recommended.
Technical data
Power: 1850 – 2200W
Power supply: 220-240V ~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve
the product without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment
(WEEE), requires that old household electrical appliances must not be disposed
of in the normal unsorted municipal waste stream. Old appliances must be
collected separately in order to optimize the recovery and recycling of the
materials they contain, and reduce the impact on human health and the
environment. The crossed out “wheeled bin” symbol on the product reminds you
of your obligation, that when you dispose of the appliance, it must be
separately collected.
GUARANTEE CERTIFICATE
This appliance has been checked in the factory. From the date of original
purchase a 24 month guarantee applies to material and production defects. The
purchase receipt and the guarantee certificate must be submitted together in
case of claim to guarantee.
The guarantee is valid only with a guaranty certificate and proof of
purchase (fiscal receipt) indicating the date of purchase and the model of the
appliance
For any technical assistance, please contact directly the seller or our head
office in order to preserve the appliance’s efficiency and NOT TO void the
guarantee. Any intervention on this appliance by non-authorized persons will
automatically void the guarantee.
GUARANTEE CONDITIONS
If the appliance shows defects as a result of faulty material and/or
production during the period of guarantee, we guarantee repair free of charge
on condition that:
- The appliance has been used properly and for the purpose for which it has been intended.
- The appliance has not been tampered with, otherwise it is not maintainable.
- The purchase receipt shall be presented.
- The appliance showing a fair wear and tear shall not be covered by this guarantee.
Therefore, any part that could be accidentally broken or having visible signs
of use in consumable products (such as lamps, batteries, heating elements…)
the aesthetic parts are excluded from the guarantee, and any defect whatsoever
resulting from non-respect of the rules for use, negligence in usage and/or
maintenance of the appliance, carelessness, wrong or improper installation,
damage during transport and any other damage not attributable the supplier.
For every defect that could not be repaired within the guarantee period, the
appliance will be replaced free of charge.
In any case, if the part to be replaced for defect, breakage or malfunction is
an accessory and/or a detachable part of the product, Beper reserves the right
to replace only the very part in question and not the entire product
Contact your distributor in your country or after sales department Beper.
E-mail assistenza@beper.com which will
forward your enquiries to your distributor.
For further information and/or for instructions for use in other languages , please visit: beper.com
CUSTOMER CARE BEPER
http://customercare.beper.com/support/home
BEPER SRL
Via Salieri, 30 – 37050
Vallese di Oppeano
Verona
Tel. 045/7134674
Fax 045/6984019
beper.com ****
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>