iTR iScrubbot M2Pro Commercial Floor Scrubber User Manual

: June 11, 2024
: iTR

iTR iScrubbot M2Pro Commercial Floor Scrubber User Manual

First, please fit the needle disc closely with floor pad;
Regarding the installation method, please refer the “Installing
Brush Disk” on page 64.

Note: After replacing the floor pad, if the height of floor pad is inconsistent with the cleaning brush disc, you are recommended to adjust the height of water retaining rubber strip.

Clean the shell

You are recommended to wipe and clean with a clean cloth once a week.

Clean the screen

Please wipe the machine screen with a clean cloth.

Note:

Machine’s screen is an electronic product. Please keep away from water .

Clean the sensor

Laser lidar:

Please gently wipe the laser lidar with a clean cloth to ensure that the lid a r surf ace is free of dirt.

Binocular camera:

Please gently wipe the binocular camera with a clean cloth to ensure that the surface of the binocular camera is free of di rt

Ultrasonic sensor:

User can selectively wipe the ultrasonic sensor according to the use of the machine. Please gently wipe the ultrasonic sensor with a clean
cloth to ensure that the surf ace of the ultrasonic sensor is free of dirt.

Adjust the water retaining rubber strip

When replacing different brush discs / pads, the height will be inconsistent, so you are suggested to adjust the height of the water retaining rubber strip. The adjustment method is as follows

Firstly, please loosen the two screws fixing the water retaining rubber strip with an Allen wrench;
Lift the whole water retaining rubber strip downward;
After adjusting to proper position, tighten the screws.

Adjust the amount of clean water

User can manually adjust the water output through the clean water regulating valve, which is located below the right side of the machine (the side with manual sewage pipe).

Increase water volume:

Clockwisely rotate the clean water regulating valve can increase the water output.

Reduce water volume:

Counterclockwisely rotate the clean water regulating valve can reduce the water output.

Replace the battery

iTR recommends you do not replace the battery by yourself. Please contact iTR after-sales engineer if necessary.

Machine storage

Please store the machine in a dry and cool place.

Maintenance frequency

Canada Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development
Canada’s licence-exempt RSS{s). Operation is subject to the following two conditions:
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be
installed and operated with a minimum distance of 20 centimeters between the radiator and your body.

IT-ROBOTICS Technology Co., Ltd.

Address: Room 203, Main Building of Jieli Building, No.135 of Jichang
iTR Road, Shangcheng District, Hangzhou, Zhejiang Sales hotline: +86-7 3958085776 / +86-7 3567194090
Tel: +86-0571-87032179 Email: it@it-robo.com
Fax: +86-0571-87837189