Caterlite CD562 Warming Tray Instruction Manual

Caterlite CD562 Warming Tray Instruction Manual

Safety Tips

• Position on a flat, stable surface.
• A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.
• Consult Local and National Standards to comply with the following:
• Health and Safety at Work Legislation
• BS EN Codes of Practice
• Fire Precautions
• IEE Wiring Regulations
• Building Regulations
• DO NOT immerse the appliance in water.
• DO NOT leave the appliance unattended during operation.
• DO NOT allow the power cord to come into contact with the hot surface of the appliance.
• Avoid using heavy cast iron vessels with the appliance; these could damage the glass surface.
• Ensure the vessel base is smooth clean and dry before use.
• Always switch off and disconnect the power supply to the appliance when not in use.
• Not suitable for outdoor use.
• If the glass surface is cracked disconnect from the power supply and consult your Caterlite agent or recommended qualified technician.
• This appliance must only be used in accordance with these instructions and by persons competent to do so.
• This appliance is not suitable for use by children.
• Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.
• If the power cord is damaged, it must be replaced by an Caterlite agent or a recommended qualified technician in order to avoid a hazard.

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your Caterlite product.

Pack Contents

The following is included:

• Caterlite Warming Tray
• Instruction Manual
  Caterlite prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage.
  Should you find any damage as a result of transit, please contact your Caterlite dealer immediately.

Operation

Note: This appliance is designed to keep food warm. DO NOT use it to reheat or cook food.

1. Connect the appliance to the mains power supply.
2. Turn the power switch to the On [I] position.
3. Turn the temperature control to the desired position.
4. Place the utensil(s) on top of the appliance

Note: Do not overload the appliance. Max. Weight: 20kgs

Cleaning, Care & Maintenance

• Disconnect from the power supply and allow the appliance to cool before cleaning.
• Use warm, soapy water and a damp cloth to clean the appliance.
• DO NOT use abrasive cleaners or pads.
• Dry thoroughly after cleaning.
• A Caterlite dealer or qualified technician should carry out repairs if required.

Troubleshooting

If your Caterlite appliance develops a fault, please check the following table before making a call to the Helpline.

appliance is plugged in correctly and switched on
Plug and lead are damaged| Call Caterlite agent or qualified technician
Fuse in the plug has blown| Replace the plug fuse
Power supply| Check power supply
Internal wiring fault| Call Caterlite agent or qualified technician

Technical Specifications

Model| Voltage| Power (max.)| Current| Max. Load| Temperature range| Dimensions (h x w x d) mm| Weight (kg)
---|---|---|---|---|---|---|---
CD562| 230V 50Hz| 230W| 1A| 20kg| 60-105°C| 35 x 550 x 350| 4.4

Electrical Wiring

This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13 amp fuse as standard. The plug is to be connected to a suitable mains socket.

This appliance is wired as follows:

• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E

This appliance must be earthed, using a dedicated earthing circuit. If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

Compliance

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible
for waste disposal in your area.

Caterlite parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.
Caterlite  products have been approved to carry the following symbol

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>