HYUNDAI TUCSON PHEV SUV, 5 doors User Guide
- June 7, 2024
- HYUNDAI
Table of Contents
HYUNDAI TUCSON PHEV
SUV, 5 doors
As of February 2021
|
---|---
| Airbag| | High voltage
power cable/
component
| | Gas tank
---|---|---|---|---|---
| Automatic rollover
Protection system
| | Seat belt
pretensioner
| | Fuse box disabling
high voltage system
| Battery
low voltage
| | High strength
zone
| | Pedestrian protection
Active system
| High voltage
Battery pack
| | Fuel tank| | Safety
valve
| Stored
gas inflator
| | High voltage
disconnect
| | Ultra capacitor,
high voltage
| Gas strut/
Preloaded spring
| | SRS control
unit
| |
| Ultra capacitor,
low voltage
| | Zone requiring
Special attention
| |
ID No.| Version No.| Version date| Page
---|---|---|---
TMA-NX4-RSP-01-202107| 01| 07/2021| 1 of 4
-
Identification / recognition
-
Immobilisation / stabilisation / lifting
■ Completely immobilize the vehicle
1. Chock the wheels and pull the EPB switch or parking lever to set the parking brake.
2.For automatic vehicles the shift button to the park(P) position.
■ For stabilize vehicle, crib at four points directly under the front and rear pillars using wooden blocks or equivalent objects
JACK/SUPPORT POSITION
Do not place cribbing such as wooden blocks or rescue air lifting bags under the exhaust system, fuel system or high voltage power cables. The failure will cause of fire, electric shock or gas leak.
ID No. | Version No. | Version date | Page |
---|---|---|---|
TMA-NX4-RSP-01-202107 | 01 | 07/2021 | 2 of 4 |
- Disable direct hazards/safety regulations
■ Access to the battery +
Do one of the following
1)Unlock all doors with the Door Unlock button on remote key or smart key, press the t/gate handle button and open the t/gate
- Press and hold the t/gate unlock button on the remote key or smart key, press the t/gate handle button and open the t/gate
- With the smart key in your possession, press the t/gate handle button and
open the t/gate
2. Raise luggage tray(2)
after raising the luggage board(1)
3. Battery(3)
in the rear floor panel.
■ Disabling procedure
– Low voltage battery
– High voltage cable
Pull the release lever to unlatch the hood. The hood should pop open slightly.
Raise the hood slightly, push the secondary latch up(1)
inside of the hood center and lift the hood(2)
Turn the ignition switch OFF and disconnect the auxiliary 12V battery positive (+) connector(A)
.
Disconnect the service interlock connector(A)
.
-
Access to the occupants
ID No.| Version No.| Version date| Page
---|---|---|---
TMA-NX4-RSP-01-202107| 01| 07/2021| 3 of 4 -
Sored energy / liquids / gases / solids
****| | max. 42L
---|---|---
| | 12 V
| | 360 V -
In case of fire Gas Strut
Gas Strut
• Risk of missile effect of t/gate
It is recommended to allow the high voltage battery to burn itself out if it is judged that it is difficult to apply copious amounts of water to the high voltage battery.
In this case, protection of the environment from smoke must be managed. -
In case of fire
Do not touch any of the high-voltage components or cables including the service plug, as doing so poses an electrocution hazard. Work on the vehicle only after the vehicle has been pulled out of the water. -
Towing / transportation / storage
OK : Notice: AWD (All Wheel Drive) vehicle must be towed with all wheels off the ground, either on a flatbed tow truck or using doilies.
Not OK :
**** ID No.| Version No.| Version date| Page
---|---|---|---
TMA-NX4-RSP-01-202107| 01| 07/2021| 4 of 4
**** ID No. TMA-NX4-RSP-01-202107
Version No. 01
Version date 07/2021
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>