MiTdir YXY-801 Portable Oral Irrigator User Manual

MiTdir YXY-801 Portable Oral Irrigator

Special Tips

• Check Battery Life : When the dental flosser is standby, Please long press the mode button, the battery life will be displayed according to the indicators. If above 76% battery life, 4 mode indicators will be on ;
  51% -75% battery life, 3 mode indicators will be on ;
  26%-50%, battery life, 2 mode indicators will be on ;
  below 25% battery life, Only Soft mode indicator will be on.

• Kind notices:

1. For new users, please try the soft mode. Gradually try the higher modes when the gums have adapted to the flossing.
2. Keep the jet tip close to your teeth with small gap. The smaller gap, the lower water pressure, the bigger gap, the stronger water pressure.

Notice for usages

For the first time use or stop using for a long time, the flosser may take a few seconds to do the flossing. Please fill few water into the nozzle hole to help the flosser back to work.

Important Safeguards

1. Do not disassemble the flosser to repair the internal components.
2. The flossing nozzles can be replaced with the specific flosser models which are produced by our company.
3. Please check the USB cable before and after use, please keep the USB cable away from heated surfaces.
4. Do not insert any objects into the flosser and nozzles.
5. Do not charge the flosser in non-dry environment.
6. Do not touch the power supply when charging the flosser.
7. Do not place or store the product in a place where it could be dropped or pulled into the bath tub, shower stall or washbasin.
8. The water tank should only be filled water or other non-corrosive liquid which is recommended by the professional doctor.

Warning

1. If you have had oral or dental surgery in the past 2 months, please consult your doctor before using this product and follow the doctor’s advice and guidance.
2. When using this product for oral cleaning in the first time, you may experience minor gum bleeding even under the case of healthy gums. This is because your gums are stimulated by the jet pressure for the first time, and usually stop bleeding after 1~2 weeks of adaptation. If your gum bleeding lasts for more than 2 weeks, it may mean abnormal conditions such as periodontal disease in your gums. In this case, please stop using the product and consult your dentist.
3. Do not use this product if the product’ s USB cable or plug is damaged, or it cannot work, falls, is damaged, or falls into any liquid.
4. Do not connect this product to a voltage system other than this device or charger.
5. This product is not suitable for persons (including children) who have poor physical, sensor or mental abilities or lack of experience, without the knowledge of the guardian.
6. Do not inject water into the bottom of tongues, ears, noses or other sensitive body parts under working status. The pressure generated by this product may cause serious damages.
7. Do not fill the water tank with the water that is over 40 degrees.

Product Descriptions

1. Jet tip lock Button
2. ON/OFF Switch
3. Mode Button
4. “Strong”
5. “Mid”
6. “Low”
7. “Soft”
8. Charging indicator
9. Jet Tip
10. Water Tank

Notes: There may be some liquid left in the water tank of the product. This is the distilled water remaining during the factory inspection. There is no any hazard for health and safety.

Product Accessories

Operating Guide

1. Start working: Please fully charge the flosser before the first time use. First press the On/Off Button, then press mode button to select working mode .
2. Filling the Water Tank : Open the water inlet of the water tank, fill the water , close the inlet , and press tightly ( Notice: The water tank is detachable and can be disassembled for filling water)
3. Install / Replace the jet tip: Insert the jet tip into the jet seat which is on the top of the Oral Irrigator. Holding the jet tip lock to remove the tip.
4. Select the mode: when first time use, press the mode button to select the appropriate cleaning mode, or according to the guidance of a professional dentist.
   Strong mode: strong power, efficient cleaning, suitable for deep cleaning;
   Mid mode : medium water pressure, suitable for daily cleaning or fresh breath;
   Low mode: gentle water pressure, suitable for beginners;
   Soft mode: suitable for sensitive teeth or gum care.

• 125PSI Strong Mode
• 80PSI Mid Mode
• 52PSI Low Mode
• 40PSI Soft Mod

Charging Precautions

1. Charge the product for 8 hours before the first time usage. Please use 5V 1A charger to charge the product;
2. Remove silicon cover from the charging seat, insert the USB pin into the charging socket of the oral irrigator ( make sure there is no residual liquid in the socket before operating );
3. Plug another side USB connector into the charger and then plug the charger into a power socket;
4. When charging, the charging indicator lights is red and slowly flashing.
   When fully charged, the charging indicator will remain green till the charger is removed

Recommended Skills

• Keep unit upright with the jet tip towards the teeth;
• Keep the product perpendicular to the mouth for best effects when using. Slightly open mouth so that the inlet water can flow out;
• Make waterflow spray to teeth and gums at a certain angle. Move Slowly the water flosser along the teeth.

Cleaning Guide

Water Tank:

• It can be washed with soapy water or placed on the top dish rack of the dishwasher. Unplug the power cord before cleaning;
• Always drain and dry the water in the tank before exposing it to a freezing temperature environment;
• Wash off the dirt with a brush or similar item, and then wipe it off with a cloth;
• Dry the water tank when not in use for a long time.

Jet Tip

• Press the jet tip lock Button to remove the jet tip. Clear it with water and wipe with a cloth;
• It is recommended to replace to the new jet tip every 3 months . Because, the Inner diameter of the jet tip may increased so the tip may not able to
• Effectively clean the teeth.

Troubleshooting Guide

Main Body:
Wipe the dirt with a cloth dampened with a mild detergent, then wipe with a dry cloth. If it is very dirty, it can be washed with water

• Do not use alcohol, benzine, thinner, etc. to wipe the product;
• Do not wash with hot water above 50 °C;
• Wipe off the water after cleaning.

Suction Pipe

• Wipe with a cloth after cleaning;
• Do not bend the suction pipe. Otherwise, the suction pipe may work in failure such as stopping water absorption during working status;
• Clean the filter net of the suction pipe in time to prevent clogging.

Water Tank Cover

• Wipe off the dirt, otherwise it will cause water leakage.

model
Water tank leaks water| The seal is damaged| Replace the seal and return to the supplier for repair
Water or other liquid is left in the water tank| Make sure to empty the water tank after using every time.
The water tank cover is not closed| Close the water tank cover
Leakage between jet tip and its sockets| The jet tip is not properly installed| Remove the jet tip and reinstall
No liquid flow or insufficient pressure| Equipment is inverted| The nozzle must be higher than the water tank
Insufficient water or liquid in the tank| Filling the tank with liquid
Wrong working mode| Select the “Strong” mode

After-sales Services

Thank you for your purchase of the MiTdir Water Flosser. We offer 12 months warranty and lifetime customer support. Please feel free to contact us if you have any questions about MiTdir products. Our After Sales Team will always try our best to assist you with any issues.

After-sales Email: mitdir_aftersales@163.com

For better experience, please read the instructions before us.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>