HEADRUSH HRG 3022 Wireless Earbuds User Guide

HEADRUSH HRG 3022 Wireless Earbuds User Guide

INTRODUCTION

Thank you for purchasing the HRB 3022 Wireless Sport Earbuds. In order to maximize your listening experience please read the following instructions.

1. Charging port
2. Increase volume/next track
3. LED indicator
4. Multi-function button (MFB)
5. Decrease volume/previous track
   

WHAT’S INCLUDED

• Wireless Sport Earbuds
• Wire clip
• USB charging cable
• Small, medium and large ear hooks
• Small, medium and large ear tips
• Instruction manual

FEATURES

• Bluetooth?’ 5.0 with Qualcomn® QCC for high-quality audio playback and conversation
• Splash- and sweat-proof nano-coating finish for an IPXS resistance rating
• Up to 7 hours of battery life

CHARGING

Fully charge your earbuds before your first use.

• Plug the micro USB cable into the micro USB port or to a USB compatible car or wall charger
• The red LED will be ON when the earbuds are charging
• The red LED will turn OFF when charging is complete
• If the earbuds aren’t used for an extended period of time, the battery will enter sleep mode for 30 minutes before the red LED will turn ON to indicate it is charging
• Charging time is approximately 1.5 hours

NOTE: If the earbuds are not charged for a long time, the battery life will be greatly reduced. We recommend that you charge your earbuds at least once every three months.

BATTERY CAPACITY STATUS

When the earbuds are connected to an iOS& device, the earbud battery status will appear in the upper right-hand corner of the device. When the battery icon is red, please charge the earbuds.

• Fully charged
  

• Low battery level
  

PAIRING

Pairing with one smartphone or other device:

• When power is off, press and hold the MFB button for about 5 seconds
• Wait until the blue light flashes slowly
• Press and hold the MFBlbutton for 2 seconds and wait until the red and blbe light flashes slowly
• Locate the Bluetooth® settings in your device and search for the earbuds
• From the list of found devices, select “HRB 3022” and connect to it
• The blue LED will flash tyvice every 5 seconds when Bluetooth® is successfully connected.

PAIRING WITH TWO SMART PHONES OR OTHER DEVICES

• After pairing is complete with the first device, turn the earbuds OFF. Then, repeat the pairing procedure with the second device
• Once it’s connected with the device, go back to the previous device to tern ON the Bluetooth® and select HRB 3022 to connect to it

NOTE: When two smartphones have different operating systems, (e.g. one has Android- and the other is iOS®) some cross-(System operations (Pause songs in Android’ play songs on iOS®) may experience delays. Please) be aware that this is normal. The earbuds will Automatically connect to your device when switched ON, provided your Bluetooth® is ON and with in range.

FIT

We recommend that you try each ear tip (small, medium and large), then perform a sound check and choose the combination that provides the best sound experience.

• Put the earbuds in your cars and adjust the position for maximum comfort and fit.

OPERATING INSTRUCTIONS

hold the MFB for five seconds. The LED will flash blue twice every 5 seconds to indicate Bluetooth®-pairing mode.

Note: The function compatibility may vary among different smartphones or devices. Not all functions are available on all devices.

LED INDICATOR

CLEANING

Your earbuds may require periodic cleaning. Remove the tips from the earbuds and wash them with a mild detergent and water. Make sure the tips are dry before putting them back on the earbuds.

IMPORTANT SAFETY INFORMATION

CAUTIONS

• Keep in a safe place free from dust, liquid and extreme temperatures
• Do not attempt to disassemble the product
• Do not use chemicals to clean the product

WARNING!

• Do not insert plug into electric outlets
• Supervise children when using equipment, this product is not a toy
• Listening to headphones at high volume levels-particularly, over extended periods of time-may damage your hearing
• If you have a pacemaker or other electrical medical devices, you should consult your physician before using this product
• The operation of switching on your Hi-Fi system or plugging in the earbuds may cause clicks which at high volume setting may affect your hearing. Therefore, always set the volume control to minimum before switching between different sources (tuner, turntable, CD player, etc.) or plugging in the earbuds
• DO NOT use earbuds while driving or cycling
• The small parts included with this product can be a choking hazard. This product is not intended for use by small children and should be kept away from children under 3 years of age.

TROUBLESHOOTING

No sound/poor sound quality

• Please check the volume on your audio device to make sure it is outputting sound
• Please make sure the earbuds are within working range of your Bluetooth0 device (10m)

Play/pause/next track/previous track in-line controls aren’t working

• Please make sure the paired Bluetooth° device supports an Audio/Visual Remote Control Profile (AVRCP)

SPECIFICATIONS

• Bluetooth€ profile: HFP/HSP/A2DP/AVRCP
• Bluetoothe range: 10m (33ft.)
• Sensitivity: 93±3dB
• Impedance: 32Q±-15%
• Frequency response: 20Hz-20kHz
• Rated input power: DC 5V, 500mA
• Playback time:  Approx. 7 hours
• Charging time:  Approx. 1.5 hours

1. A2DP=Advanced Audio Distribution Profile, AVRCP=Audio Video Remote Control Profile, HSP-1-landset Profile, HFP=Handsfree Profile.
2. Approximate playback time, battery life depends on individual use and may be more or less than specified.

INDUSTRY CANADA NOTICE R55247

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

• this device may not cause interference, and
• this device must accept any interference, including interference that may cause undesired operation of the device.

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of Industry Canada.

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth® SIG, Inc. and any use of such marks by The Source (Bell) Electronics Inc. is under license. Other trademarks and trade names are those of their respective owners.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

• this device may not cause harmful interference, and
• this device must accept any interference received, including interference that may cause undesired operation.

Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equip-ment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device contains licence-exempt transmitters)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

• This device may not cause interference.
• This device must accept any interference, including interference that may cause undesired operation of the device.

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment could be installed and operated with minimum distance Ocm between the radiator and your body. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

The portable device is designed to meet the requirements for exposure to radio waves established by the ISED These require-ments set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the head.

THE SOURCE – WARRANTY

The Source warrants that this product will be free from defects in materials and workmanship for a period of one (1) year from the date of purchase. Within this period, simply take the product and your proof of purchase to any The Source store or participating dealer and the product will be replaced (where available) without charge. Any product which has been subject to misuse or accidental damage is excluded from this warranty. This warranty is only applicable to a product purchased through The Source company-owned stores or participating dealers in Canada where the warranty is included with the product. While this warranty does not confer any legal rights other than those set out above, you may have additional statutory rights which will vary under the laws of the various countries, states, provinces and other govern-mental entities in which The Source operates. This warranty is subject to all statutory rights you may have in Canada.

Imported by: The Source Barrie, Ontario, Canada, L4M 4W5 Manufactured in China

Please Recycle

© 2019 The Source All rights reserved.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>