HEADRUSH 8092991 Wireless Speaker Instruction Manual
- June 5, 2024
- HeadRush
Table of Contents
- HEADRUSH 8092991 Wireless Speaker
- INSTRUCTION MANUAL
- PRODUCT OVERVIEW
- OPERATION
- STATUS INDICATOR
- CHARGING
- PAIRING
- HANDSFREE SPEAKERPHONE
- CONNECT TO YOUR PC VIA BLUETOOTH®
- TECHNICAL SPECIFICATIONS
- TROUBLESHOOTING
- INDUSTRY CANADA NOTICE
- THE SOURCE – WARRANTY
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
HEADRUSH 8092991 Wireless Speaker
INSTRUCTION MANUAL
WHAT’S INCLUDED:
- Speaker
- USB-C charging cable
- 3.5mm audio cable
- Instruction manual
COMPONENT IDENTIFICATION
- Power button
- Mode button
- Mic hole
- Play/Pause
- Increase/decrease volume
- Line in port
- Charging LED indicator
- Charging port
PRODUCT OVERVIEW
You can use this item with any compatible, Bluetooth®-enabled device to stream
music and enjoy hands-free calling. Please read this manual first before
using.
This speaker has an IPX6 rating: protected against high-pressure water jets
from all directions.
OPERATION
TO | DO THIS |
---|---|
Power ON | Press the button. |
Play/pause | Press the button to play, press to pause, press again to resume. |
Next track | Press and hold the button for 2 seconds. |
Previous track | Press and hold the button for 2 seconds. |
Increase volume | Press the button. |
Decrease volume | Press the button. |
Answer/end call | Press the button. |
Reject an incoming call | Press and hold the button. |
TWS | Press and hold the and buttons at the same time for 2 seconds. |
Reset | Press the and M (Mode) buttons at the same time for 2 seconds. |
STATUS INDICATOR
Mode indicator
| Rapidly flashing blue| Pairing mode
---|---|---
Steady blue| Paired
Steady red| Line in mode
Charge indicator
| Steady red| Charging
Steady green| Fully charged
CHARGING
Use the included charging cable to fully charge the speaker before first use. It will take approximately 4 hours to fully charge.
- The red LED will be ON while the speaker is charging
- The red LED will turn green once charging is complete
TIP: When the battery is low, the speaker will beep every few seconds, please charge the speaker. If it is not plugged in to charge within approximately 15 minutes, it will turn OFF.
PAIRING
- Press and hold the button to turn the speaker ON. The blue LED will flash.
- Turn Bluetooth® ON in your device settings and select “HRSP 5041”.
- Once paired successfully, the blue LED will be ON and the speaker will chime.
- If you fail to pair your device or you want to pair it with a new device, please repeat the steps outlined above.
NOTE: If there is no device paired within 15 minutes the speaker will
turn OFF. To un-pair, disconnect in your device settings.
NOTE: The speaker will automatically pair with previously paired devices
provided Bluetooth® is ON and within range. The speaker will chime to indicate
that it has successfully re-paired.
TWS (TRUE WIRELESS STEREO) CONNECTION
- Ensure that neither speaker is connected to your phone via Bluetooth® and turn Bluetooth® OFF on your device.
- Press and hold the button on both speakers to turn them ON. The button on both speakers will flash.
- On either speaker, press and hold the and buttons at the same time for 2 to 3 seconds until the speaker chimes. The speaker will chime again after 2 seconds to indicate that TWS has connected successfully.
- Turn Bluetooth® ON in your phone’s settings and select “HRSP 5041”.
- The speaker will chime and both LEDs will turn ON, this indicates successful pairing.
NOTE: When your device is connected via Bluetooth in TWS mode, you can press both the M and + buttons at the same time for 3 seconds to clear the pairing list for the device.
HANDSFREE SPEAKERPHONE
When a smartphone is connected to your speaker follow the steps below to take calls handsfree.
- If there is an incoming call while streaming music, the speaker will ring.
- Press the button to answer a call.
- Press the button to end a call.
- Press and hold the HR button to reject a call.
LINE-IN (AUX IN) MODE
- Use the supplied 3.5mm audio cable to connect the speaker directly with your device.
- Turn Bluetooth® OFF on your device.
- Press the M (mode) button. The HR LED button will be red while in this mode.
NOTE: LINE-IN will take priority over the Bluetooth® connection.
CONNECT TO YOUR PC VIA BLUETOOTH®
To listen to music:
- Select “HRSP 5041 Stereo” by left clicking on the speaker icon in the lower right corner of your computer screen.
To Answer Incoming Call
- Select “HRSP 5041 Hands-Free AG Audio” by left clicking on the speaker icon in the lower right corner of your computer screen
NOTE: Check the volume levels before using as a speaker phone and when a call is coming through.
TECHNICAL SPECIFICATIONS
- Output power: 4W
- Bluetooth® version: 5.1
- Battery capacity: 3.7V/1400mAh
- Charging time: 2-3 hours
- Frequency response: 90Hz-18kHz
- Operation distance: Up to 10m (33ft.)
- TWS distance: 3.5m (11.5ft.)
- Playtime: 6 hours
- Drivers: 44mm
- Standby time: 24 hours
NOTE: This speaker is in compliance with the specified Bluetooth® version. It does not guarantee compatibility with all the functions on every Bluetooth®-enabled device. Please check your mobile phone’s user manual for compatibility and functionality.
TROUBLESHOOTING
No Sound:
- Ensure the speaker is charged and has enough battery power for operation
- Ensure the speaker is switched ON
- Ensure the Bluetooth® device is ON
- The volume of the speaker is too low, adjust the volume to an appropriate level
NOTE: If the speaker beeps every few seconds, the battery is low. Please recharge the speaker.
WARNING: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
RSS 247
INDUSTRY CANADA NOTICE
This device contains license-exempt transmitter/receiver(s) that comply with Innovation Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
THE SOURCE – WARRANTY
The Source warrants that this product will be free from defects in materials
and workmanship for a period of twelve (12) months from the date of purchase.
Within this period, simply take the product and your proof of purchase to any
The Source store or participating dealer and the product will be replaced
(where available) without charge. Any product which has been subject to misuse
or accidental damage is excluded from this warranty.
This warranty is only applicable to a product purchased through The Source
company-owned stores or participating dealers in Canada where the warranty is
included with the product. While this warranty does not confer any legal
rights other than those set out above, you may have additional statutory
rights which will vary under the laws of the various countries, states,
provinces, and other governmental entities in which The Source operates. This
warranty is subject to all statutory rights you may have in Canada.
Imported by:
The Source, Barrie, Ontario, Canada, L4M 4W5 Manufactured in China
www.thesource.ca © 2021 The Source. All rights
reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>