HEADRUSH FRFR-108 MKII 8 Inch Guitar Speaker User Guide
- June 1, 2024
- HeadRush
Table of Contents
HEADRUSH FRFR-108 MKII 8 Inch Guitar Speaker
HEADRUSHFX.COM/SUPPORT
For articles, videos, and web support.
GETTING STARTED
Package Contents:
FRFR-108 MK2, Power Cable, Quickstart Guide, Safety & Warranty Manual
- REGISTER YOUR PRODUCT
- DOWNLOAD THE USER GUIDE
SETUP
Note : Consult the full User Guide for additional safety precautions.
Example A: One FRFR-108 MK2 (Mono)
Connect the Left (Mono) output of your guitar or bass multi-FX/amp modeling
pedal to the input on a FRFR-108.
Example B: Two FRFR-108 MK2s (Stereo)
Connect the Right and Left (Momo) outputs Of your or guitar bass multi-FX/amp
modeling pedal to the inputs Of your FRFR-108.
Example C: Two FRFR-108 MK2s (Mono) Connect the Left (Mono)
output of your guitar or bass multi-FX/amp modeling pedal to the input of one
FRFR-108, and then connect the Mix Out of that FRFR-108 to the input of
another.
FEATURES
- A. Power Input: Use the included power cable to connect this input to a power outlet.
- B. Power Switch: Use this switch to power the loudspeaker on or off.
- C. Fuse: If the unit’s fuse is broken, lift this tab to replace the fuse. Replace it with a fuse with an appropriate rating (printed under the unit’s power cable input). Using a fuse with an incorrect rating can damage the unit and/or fuse.
- D. Input 1/2: Use a standard XLR cable or 1/4″ (6.35 mm) TRS cable (not included) to connect your audio source to these inputs.
- E. volume 1/2: Turn each knob to adjust the volume of each input. Set these to the minimum (counterclockwise) position before turning on the power.
- F. Mix Out: Use a standard XLR cable (not included) to connect this output to the input of another loudspeaker (i.e., another FRFR-108).
- G. HPF: If the speaker sounds too muddy or boomy due to a large stage or rehearsal room, press this button to reduce the speaker’s low-end frequencies. This will simulate the speaker being put on a standard speaker stand.
- H. Ground: Press this button to reduce hum or noise.
- I. Bluetooth Pair: Press and release this button to put the speaker into Bluetooth Pairing mode, and then select “FRFR-108” from your device’s Bluetooth settings. To disconnect a paired Bluetooth device, press and release this button again.
- J. Bluetooth LED: This blue LED is flashing when the speaker is in pairing mode, lit solid when a device is paired, and OFF when a Bluetooth device is not paired.
- K. Bluetooth Volume: Turn to adjust the Bluetooth signal’s volume.
- L. Sig/Limit: This LED lights up green when an audio signal is sent to the loudspeaker—it flashes at lower levels and lights solidly at higher levels. The LED lights up red when output limit/protection is active—if the LED is lit red continuously, reduce the volume of your audio source.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>